Advertisement
Specifications
DSC Device Types:
Hears and translates DWS, PIR, Glass Break,
Fob, Panic.
Receiver and Transmitter: Listens to SAW and crystal transmitters. Talks
to SAW receivers.
Backup batteries:
Three AAA Alkaline.
External supply:
8.5 to 13 VDC or 6-9 VAC
Standard: Resolution RE012: 12VDC, 50mA.
Optional: GE 60-898-ITI, for securing screw
Wire connection polarity DOESN'T matter!
Current draw with supply: 4mA, normal operation.
Power Fail Conditions:
12V DC gone. Translator device ID
supervisories (including low battery reports)
are stopped during 12V DC loss.
Back-up Battery Life on 12V DC Fail:
Device Low Battery:
When approximately 48 hours remain in back-up.
Housing dimensions:
4x6x1 inches
Specifications subject to change without notice.
Internal Picture
Indicator LEDs & buzzer
RE224DT_DSC-to-2GIG_Translator
Page 3 of 4
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
72 hours (cumulative).
2 Antennas for:
Dual Diversity Receive and
Dual Diversity Transmit
Note: Antennas mounted
on outer terminals
Unused:
Device Type Indicator LEDs
and Enrollment button
Battery bucket for 3 AAA alkalines
Tamper Switch & spring
Power Terminals
POLARITY DOESN'T MATTER
15-Oct-14
Notices
"GE", "Honeywell", "2GIG" and "DSC" are trademarks owned by General Electric Company,
Honeywell International Inc., 2GIG Technologies, Inc., and Tyco Safety Products Canada LTD,
respectively.
Resolution Products, Inc. products will function with one of either GE, DSC, 2GIG or Honeywell
systems. However, no Resolution product is produced by, endorsed by, nor is officially
associated with GE, Honeywell, 2GIG or DSC. Resolution recommends verifying proper
enrollment and operation, per control panel installation instructions, at installation.
Do not use Translator for life safety devices, such as smoke or CO sensors.
Patent Pending
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could
void the user's authority to operate this equipment.
FCC ID: U5X-RE224
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE224
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne
et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante.
This radio transmitter (identify the device by certification number, or model number if Category II) has been
approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain
and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a
gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son numéro de modèle s'il fait
partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les
types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur.
- Resolution-supplied 8.5" monopole antenna
RE224DT_DSC-to-2GIG_Translator
Page 4 of 4
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
15-Oct-14
Advertisement
