jablotron JK-82UK Oasis Quick Start Manual

Installation of the JK-82 kit shall only be undertaken by technicians holding
a certificate issued by an authorized distributor. This simplified installation
manual only describes the basics, for more details see the manuals of
particular devices.
1. Factory-default pre-enrolled devices
Address Device
03 JA-81M door detector
04 JA-80P PIR detector
48 RC-86 keyfob
49 JA-80F keypad unit
50 JA-80L indoor siren
RC-89 doorbell button*
* The RC-89 doorbell button is not delivered with the JK-82
2. Before installation
Have a SIM card ready for the GSM communicator which is
activated and does not require a PIN code to register to a GSM
network. If it is a prepaid card it should be sufficiently topped up.
3. Control panel and keypad installation
1. Attach the Control Panel (CP) to the desired location
2. Insert the SIM card into the communicator's SIM card holder.
3. Connect back-up battery to the CP (attach it securely with
adhesive tape).
4. Connect the mains to the CP – its green LED will start flashing
5. The communicator's red LED should be lit during registration to
the GSM network, and should turn off within 1 minute. If it
starts flashing instead, turn off the power (mains & battery) and
check that the SIM card functions properly in a mobile phone.
6. Connect up the batteries in the JA-80F keypad – service
mode should be displayed (if not, disconnect the keypad
batteries, check that the control panel is powered up and
reconnect the keypad batteries).
Keeping the ∗ key pressed while connecting the keypad
batteries will open the keypad's internal menu which allows
you to select the desired language (English = 1), to exit this
menu press the # key.
If you exit Service mode accidentally, it can be re-entered by
The JK-82 / JK-82 "Oasis" wireless alarm kit
UK
The JK-82 / JK-82
Note
Delayed reaction
Delayed reaction
Buttons and pre-enrolled
Connect a magnetic door
sensor to its IN input
Pre-enrolled to the JA-80L
ON
OFF
1 2 3 4
"Oasis" wireless alarm kit
UK
keying in ∗ 0 8080.
Close the keypad's flip cover to save the battery while in the
service mode
7. Key in 98101 - to set texts of the communicator to English
language
8. Enter 922 to measure the GSM signal – it should be at least
2/4 (if it is not, find another location for the control panel or try
another provider's SIM card).
9. Exit GSM measurement mode by pressing the # key.
10. Before attaching the JA-80F keypad, test that it functions
correctly at the desired location. We recommended wiring up a
magnetic door sensor (provided with the kit) to the keypad's IN
input. This will ensure that the keypad is "woken up" whenever
the door is opened (to indicate system status, to make entrance
UK
delay beeps and to have the access card reader ready for
reading cards).
4. Installing the detectors and the siren
1. Install the JA-81M magnetic detector, select its reaction via the
internal DIP switch (INS/DEL), connect its battery up and close
the cover.
RESET
1/2
mag.senzor
ON/OFF
Reaction
tamper
switch
1k
external
senzor
LEDs
SIM card
Communicator
Main board
Antenna
Tamper switch
Transformer
Mains terminal
Back-up battery
GSM antenna
Digital bus connector
MKE58102