ROMAN ET10 Instruction Manual

Sliding Door
Instruction Manual
Consumer Guarantee -
which is enclosed with this product. Failure to validate the Guarantee will mean only the 1 Year Statutory Guarantee will apply.
ET Sliding Door:CSP 4/5/10
1 Check you have the correct product. Please look at the labels on the side of the product packaging.
2 Check all the product components are in the box and the fixing kits are complete. Please check this with the component check list below.
3 Unpack your product and handle it with care.
4 Please check the product for defects or damage. Once the installation has commenced we cannot accept responsibility for any defects or
damage to the products.
5 Please take the time to read these instructions prior to installing your product.
6 Before you commence any drilling check there are no hidden electrical cables and/or water pipes in the walls.
7 No attempt should be made to re-work the toughened safety glass.
8 The installation of the product should be performed by two persons.
9 It is strongly recommended that the walls the product is going to be installed on are vertical.
10 It is strongly recommended the product is fitted on tiled surface or similar waterproof surface.
11 It is strongly recommended the walls are tiled and grouted before the product is installed.
12 If the walls and/or the tray are not level you will not achieve maximum adjustment of the product.
13 Pictures used are for illustration purposes only, product designs may alter slightly as a result of continuing product development.
14 We do not stipulate where the European Standard Kite Mark should be positioned on the glass panels when being
factory assembled.
Component Check List: Supplied
• Roman's toughened glass is completely safe for use in our shower enclosures and bath screens; providing our products are installed
according to our guidelines.
• It is important to note, that the glass must not be mounted or 'pinched' in such a way that would cause a stress point to develop in the
glass. In addition, it must not be subjected to any sharp impact or severe temperature fluctuation which may also cause a stress point to
develop in the glass.
Description
• Roman's toughened glass is physically and thermally significantly stronger than standard glass. During our toughening process the
stresses contained within any glass are balanced so if in the unlikely
situation any of the above occurs and the glass breaks, the glass will
shatter safely into small thumbnail sized blunt fragments.
Wall Profiles
Frame Cover Trims
Screw Cover Trims
Top Caps
Vertical Main Frame
Bearing Assembly
Door Stop
Door Glass
Vertical Door Seal
Panel Clip
Vertical Panel Seal
Panel Seal
Panel Glass
Door Handle
IMPORTANT PRE-INSTALLATION CHECKS
Please make sure the purchaser/end user completes and returns the Guarantee card
Some Important Information to read before you install your Product.
11:33 Page 1
IMPORTANT INFORMATION
Quantity
2
2
2
2
2
4
4
1
1
2
1
2
1
2
ET
Equipment Check List: Not Supplied
Description
Mains or Battery Drill
Fixing Kit Components
6mm Masonry Drill
Spirit Level
Pozi Screwdriver
Sealant Gun
Description Bathroom Sealant
Tape Measure
Pencil
No4 x ¼" pan head screws
40 mm Screws (wall profiles)
Wall Plugs
2.5mm drill bit
Profile Cover Caps
Branding Badge
Allen Key 4mm
Quantity
6
6
6
1
2
Ref: ET May 10
1
1