HWH SPACEMAKER Operator's Manual
Room extension systems, computer-controlled leveling system
Hide thumbs
Also See for SPACEMAKER:
- Operator's manual (22 pages) ,
- Operator's manual (17 pages) ,
- Operator's manual (27 pages)
Table of Contents
Advertisement
Quick Links
OPERATOR'S MANUAL
HWH COMPUTER-CONTROLLED
625S SERIES LEVELING SYSTEM
SPACEMAKER ROOM EXTENSION SYSTEMS
Ph: 800/321-3494 (or) 563/724-3396 | Fax: 563/724-3408
AP45271
H H
W
CORPORATION
R
AND
R
FEATURING:
Touch Panel Leveling Control
Single Step BI-AXIS Hydraulic Leveling
Straight-Acting Jacks
Multiple Room Extensions
HWH COMPUTERIZED LEVELING
R
EXCESS
SLOPE
AUTO
LEVEL
NOT IN
PARK/
BRAKE
AUTO
STORE
TRAVEL
EMERGENCY
MODE
STOP
CAUTION!
UNDERSTAND OPERATOR'S MANUAL BEFORE USING. BLOCK FRAME AND TIRES
SECURELY BEFORE REMOVING TIRES OR CRAWLING UNDER VEHICLE.
HWH CORPORATION
(On I-80, Exit 267 South)
2096 Moscow Road | Moscow, Iowa 52760
www.hwh.com
R
R
EXTEND
EXTEND
MANUAL
RETRACT
RETRACT
ML45272/MP04.2804
02SEP09
Advertisement
Table of Contents
Related Manuals for HWH SPACEMAKER
Summary of Contents for HWH SPACEMAKER
- Page 1 CORPORATION OPERATOR’S MANUAL HWH COMPUTER-CONTROLLED 625S SERIES LEVELING SYSTEM SPACEMAKER ROOM EXTENSION SYSTEMS FEATURING: Touch Panel Leveling Control Single Step BI-AXIS Hydraulic Leveling Straight-Acting Jacks Multiple Room Extensions HWH COMPUTERIZED LEVELING EXCESS SLOPE EXTEND EXTEND AUTO LEVEL NOT IN MANUAL...
-
Page 2: How To Obtain Warranty Service
HWH CORPORATION personnel will contact you to the problem quickly. If the dealer has difficulty solving determine whether or not your claim is valid. If it is, HWH the problem, he should immediately contact the Customer CORPORATION will authorize repair or replacement of the Service Department, at HWH CORPORATION. -
Page 3: Control Identification
625S / 725 / 2000 SERIES LEVELING SYSTEM COMPUTER-CONTROL "EXCESS SLOPE" Indicator light LOWER FRONT Manual button "NOT IN PARK" Indicator light RAISE FRONT Manual button HWH COMPUTERIZED LEVELING JACK DOWN AUTO LEVEL Indicator light Indicator light (4) red EXCESS SLOPE "AUTO LEVEL"... -
Page 4: Cold Weather Operations
For cold weather information see "COLD WEATHER OPERATIONS" below. The HWH systems with a computer processor monitor the pump run time and will turn the pump off if the run time exceeds a specified time. This time can vary with different systems. Due to available electronics or system design, the pump run time programs will also vary. -
Page 5: Operating Procedures
OPERATING PROCEDURES GENERAL INSTRUCTIONS Maintain adequate clearance in all directions for vehicle, room If the hand / auto brake is not set when the "AUTO LEVEL" extensions, awnings, doors, steps, etc. Vehicle may move in button is pressed, the "NOT IN PARK/BRAKE" light will any direction due to jacks extending or retracting, settling of come on. - Page 6 "AUTO LEVEL", "AUTO STORE" or the SLOPE" light will remain on if the ignition is in the "ON" or "CANCEL" button on the HWH touch panel will "ACC" position, until the jacks have been fully retracted stop the automatic leveling function.
- Page 7 "AUTO LEVEL", "AUTO STORE" or the the jacks have retracted to the STORE position. If "CANCEL" button on the HWH touch panel will desired, the jacks can be stored with the ignition key stop the automatic store function.
- Page 8 OPERATING PROCEDURES MANUAL HYDRAULIC OPERATION 1. Place transmission in the recommended position for parking Any jack not used for leveling can be extended to the the vehicle, and set the parking brake. Turn the ignition to the ground. This provides additional stability against wind and "ACCESSORY"...
- Page 9 Use the manual valve release for retracting the jacks only removed to gain access. Open valve 1-1/2 to 2 full turns. if the STORE feature on the HWH control panel will not DO NOT turn the 1/4" valve release nut more than retract the jacks.
- Page 10 KEEP PEOPLE AND OBSTRUCTIONS room. DO NOT reverse direction of the room, contact CLEAR OF ROOM WHEN OPERATING. HWH Customer Service for assistance 1-800-321-3494. NOTE: Make sure there is adequate clearance to fully NOTE: Releasing the ROOM CONTROL SWITCH will halt extend the room.
- Page 11 A MANUAL RETRACT WINCH PROVIDED place the RATCHET LEVER in its ON position and slowly BY HWH IS EQUIPPED FOR MANUALLY RETRACTING THE rotate the WINCH HANDLE clockwise until the ROOM ONLY. IT IS NOT TO BE USED FOR LIFTING OR ANY RATCHET LEVER locks.
- Page 12 IMPORTANT: If at any stage something is not VALVE understood or if the room begins to bind DO NOT force RELEASE the room, contact HWH Customer Service for assistance OPEN 1-800-321-3494. NOTE: Leave the solenoid valves open and the threaded rods in place until the room has been serviced.
-
Page 13: Maintenance
ROOM EXTENSIONS The HWH room mechanisms need no maintenance. Any visible mechanism can be kept clean by washing DO NOT grease or lubricate any parts of the HWH with water. Refer to the vehicle manufacturer for mechanism. correct maintenance of the room seals. - Page 14 To help reduce the corrosion of jacks after exposure to anti- continue to absorb moisture from the air even after they icing / deicing agents, thoroughly wash jacks with warm have dried. This can facilitate corrosion of metallic soapy water. components, such as HWH jacks. MP44.0502 22NOV16...
- Page 15 Move the adjustment for that light very, very, slightly in qualified RV repair center, your vehicle or coach the OPPOSITE direction that is given in the above manufacturer, or HWH CORPORATION for service or repair. instructions for LED’s A, B, C, and D. This will allow MP44.1501 20APR09 MP45.3259...
- Page 16 INFORMATION/INSTRUCTION SHEET HYDRAULIC SOLENOID VALVE INDENTIFICATION - MANUAL OPERATIONS - REPLACEMENT REPLACEMENT VALVES WILL HAVE A VALVE RELEASE CAM SOLENOID VALVES WITH CAM RELEASE BREATHER CAP W/NUT DRIVER 1 1/2" DIAMETER SOLENOID VALVE CAM RELEASE VALVE CLOSED Default position THE BREATHER CAP IS NOTE: The cam release may be LOCATED ON THE TOP rotated in any direction on the...