List Of Messages - Canon ELURA 80 Instruction Manual

List of Messages

Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY
PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE
CASSETTE
CHECK THE INPUT
CONDENSATION HAS
BEEN DETECTED
TAPE END
CHECK THE CASSETTE
[REC MODE]
CHECK THE CASSETTE
[AUDIO MODE]
CHECK THE CASSETTE
[BLANK]
WRONG FORMAT
PLAYBACK NOT
POSSIBLE
CHECK THE CASSETTE
[WRONG FORMAT]
HEADS DIRTY, USE
CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
COPYRIGHT
PROTECTED DUBBING
RESTRICTED
Memory Card Related Messages
Message
NO CARD
THE CARD IS SET FOR
ERASURE PREVENTION
NO IMAGES
CARD ERROR
CARD FULL
NAMING ERROR
138
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
Cassette is protected. Replace the cassette or change the
position of the protect switch.
Camcorder stopped operating to protect the tape. Unload and
reload the cassette.
DV cable or USB cable is not connected, or the connected digital
device is turned off.
Condensation has been detected in the camcorder.
Tape reached the end. Rewind the tape or replace the cassette.
You attempted to perform audio dubbing on a tape recorded in a
mode other than the SP mode.
You attempted to perform audio dubbing on a tape recorded in 16-
bit or 12-bit 4-channel sound.
You attempted to perform audio dubbing on a tape with a blank
section.
You attempted to play back a tape recorded in HD format.
You attempted to perform audio dubbing on a tape recorded in HD
format.
Video heads are dirty. Clean the video heads.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also appear
when an anomalous signal is received during analog line-in
recording, or during analog-digital conversion of a copyright
protected tape.
Memory card not is inserted into the camcorder.
SD Memory Card is set for erasure prevention. Replace the card
or change the position of the protect switch.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or
play back the image.
The error may be temporary. If the message disappears after 4
seconds and " " flashes red, turn the camcorder off, remove
the card and reinsert the card. If "
continue recording/playback.
No remaining capacity on the memory card. Replace with another
card or erase images.
File or folder number has reached the maximum value.
Explanation
Explanation
" changes to green, you can
22
13
144
16
83
142
–
85
85
85
–
–
142
82
82
89
89
–
–
–
92