Gree GWH24YE-S6DBA2A Quick Start Manual page 81

Steps
9.Remove motor support
Twist off the tapping screws fixingthe motor
support, pull it upwardsand then remove the
motor support.
10.Remove isolation sheet
Twist off the screws connecting isolation sheet
and end plate of condenser and chassis, and
then remove the isolation sheet.
11.Remove 4-way valve and Electronic Expansion Valve
a Unsolder the pipeline between compressor,
condenser, gas and liquid valve, and then
remove the 4-way valve. (note: release all
refrigerant before unsoldering).
Unsolder weld point of
b
valve and outlet pipe of condensator. Then
remove the electronic expansion
block the electronic expansion
it. (Note: be fore unsoldering,discharge
refrigerants completely)
78
Procedure
electronic expansion
valve
Do not
when unsoldering
motor support
isolation sheet
Service Manual
4-way valve
Electronic Expansion Valve
Installation and Maintenance