Ssl Settings (Known As Secure Connections Feature); Auto Discovery; Control System Settings; Room View Settings - Philips 43HFL5114 Professional Installation Manual

7.10.2

SSL settings (known as Secure connections feature)

This is a section that is enabled by an ON/OFF toggle. The default for this feature is OFF. In order for
this to work, it is necessary to have at hand some software certificates (more about what software
certificates are here: https://www.computerhope.com/jargon/c/certific.htm).
The certificates can be uploaded to the device using the USB as follows:
o copy the certificates on a USB Stick
o insert the USB Stick in any slot available on the device and follow the instructions below

ROOT CA: Pressing this button enables searching on the Android managed files (Similar
with e.g. Windows Explorer). By this means the installer can select a Root Type Certificate
which will be stored in-memory by the APP

Certificate: Pressing this button enables searching on the Android managed files (Similar
with e.g. Windows Explorer). By this means the installer can select the actual Certificate to
be used in the TLS connection and which will be stored in-memory by the APP

Private Key: Pressing this button enables searching on the Android managed files (Similar
with e.g. Windows Explorer). By this means the installer can select the primary key (pem
file) to be used in the TLS connection and which will be stored in-memory by the APP

Strict Mode: When it is disabled, it ignores the problems that might appear with TLS
7.10.3

Auto Discovery

This is a section that is enabled by an ON/OFF toggle. The default for this feature is OFF. Auto-discovery
is a mechanism for Crestron control systems to locate other Crestron devices on the same network.
The only parameter to change is the PORT. Most used value for the port is the default: 41794
7.10.4

Control System Settings

This is a section that is enabled by an ON/OFF toggle. The default for this feature is ON. When this
feature is enabled, the Fusion in the Cloud (described below) feature is disabled. This Crestron Feature
addresses configuration for Virtual Control 4 and the Crestron Controller physical device.
o [Host address + Port]: The ipv4 address of the Crestron Virtual Controller instance. For further
reference look at the Crestron Virtual Controller setup
o [IpID]: The unique identificator for the Crestron Virtual controller instance (use the
hexadecimal value)
o [Room ID]: Unique identifier of the room, that is set in the Crestron Virtual Controller instance
7.10.5

Room view settings

This is a section that is enabled by an ON/OFF toggle. The default for this feature is OFF.
This is a section to configure the Room View software. For configuring a connection with RoomView
the following parameters are needed:
Room IpID: The unique identifier of the display in (for) the room (use the hexadecimal value).
7.10.6

Fusion in the Cloud

This is a section that is enabled by an ON/OFF toggle. The default for this feature is OFF. When this
feature is enabled, the Control System Settings (described above) feature is disabled.
- 117 -