Table of Contents
Advertisement
Adjusting the brightness (Continued)
4
Press the SEL/PUSH EXEC dial
G to lock the shutter speed.
To readjust the shutter speed, repeat
steps from 2.
z Tips
• It is difficult to focus automatically at a lower
shutter speed. Manual focusing with your
camcorder attached to a tripod is recommended.
• When recording under fluorescent lamps,
sodium lamps, or mercury lamps, the picture
may flicker or change colors, or may have
horizontal bands of noise. You may be able to
improve the situation by adjusting the shutter
speed to 1/100 if the power frequency of your
area is 50 Hz, or 1/60 in a 60 Hz area.
• You can switch the shutter speed display
between seconds and degrees ([SHUTTER
DISPLAY], p. 95).
To adjust the shutter speed
automatically
Press the SHUTTER SPEED button D
once.
The shutter speed value disappears, or
appears next to the shutter speed value.
When AE is fixed,
shutter speed value.
Adjusting the exposure
AUTO (
MANUAL (all)
1 When you set AUTO/MANUAL switch
in [SPOT METER] or [SPOT METER/
FOCUS]
2 When all of iris, gain and shutter speed
are set manually.
3 When the last setting of the exposure is
set to AUTO, and any item in 2 is set to
AUTO.
40
appears next to the
)
MANUAL (
4 When the last setting of the exposure is
set to MANUAL, and any item in 2 is set
to AUTO.
b Notes
• When you set AUTO/MANUAL switch to
AUTO, or press [EXEC] on the [SPOT
METER] or [SPOT METER/FOCUS] screen,
the exposure is returned to AUTO.
Adjusting the volume of light
(ND filter)
You can record the subject clearly by using
the ND filter B when the recording
environment is too bright.
The ND filters 1, 2 and 3 reduce the volume
of light to about 1/4, 1/16 and 1/64,
respectively.
If
flashes during the iris automatic
adjustment, set the ND filter to 1. If
flashes during the iris automatic
adjustment, set the ND filter to 2. If
flashes during the iris automatic
adjustment, set the ND filter to 3.
The ND filter indicator will stop flashing
and remain on the screen.
If
The ND filter icon will disappear from the
screen.
b Notes
• If you change the ND filters B during
recording, the movie and sound may be
)
distorted.
• When adjusting the iris manually, the ND filter
icon does not flash even if the light volume
should be adjusted with the ND filter.
• If the camcorder cannot detect the ND filter
position (OFF/1/2/3),
Make sure that the ND filter is set correctly.
z Tips
• While recording a bright subject, diffraction
may occur if you close the aperture further
down, resulting in a fuzzy focus (this is a
common phenomenon with video cameras). The
ND filter B suppresses this phenomenon and
gives better recording results.
flashes, set the ND filter to OFF.
flashes on the screen.
Advertisement
Table of Contents
