Custom Panel General Information - AGA marvel MP36BF2 Installation Instructions Manual

Custom Panel General Information

Custom finishing options
• All installations must allow for the refrigerator
and freezer door to open a minimum of 90˚.
• For side wall or corner installation, allow for a
standard 3" (7.6 cm) cabinet filler to assure
door(s) opens 90˚.
Note: If a custom handle is used, a wider filler
may be necessary.
Custom Door Panel Installation
1
Remove handle side cabinet screws
and trim with a phillips screwdriver.
3
Remove bracket.
• Panel thickness must not exceed 1" (2.5 cm)
on hinge side. Thicker panels will interfere with
door swing and clearance.
• Door panels should be installed after the
refrigerator has been plugged in for at least 24
hours.
2
x13
x13
Remove all screws from handle side door trim.
Remove two screws from top and bottom door trim.
4
2-13/16" 2-13/16"
(7.1 cm) (7.1 cm)
Bottom-mount Bottom-mount
Measure and mark the first hole for each bracket.
14
Remove handle side door trim.
2-1/16" 2-1/16" 1-11/16" 1-11/16"
(5.2 cm) (5.2 cm) (4.3 cm) (4.3 cm)
Back of panel Back of panel
"Z" bracket "Z" bracket FOL bracket FOL bracket
x2
x2
2-1/8" 2-1/8" 2-1/8"
(5.4 cm) (5.4 cm) (5.4 cm)