Table of Contents
Advertisement
12
www.electrolux.com
7.2 Pan supports
The pan supports are not
resistant to washing in a
dishwasher. They must be
washed by hand.
1. Remove the pan supports to easily
clean the hob.
Be very careful when you
replace the pan supports
to prevent the hob top
from damage.
2. The enamel coating occasionally can
have rough edges, so be careful when
you wash the pan supports by hand
and dry them. If necessary, remove
stubborn stains with a paste cleaner.
3. After you clean the pan supports,
make sure that they are in correct
positions.
4. For the burner to operate correctly,
make sure that the arms of the pan
8. OVEN - DAILY USE
WARNING!
Refer to Safety chapters.
8.1 Cooling fan
When the appliance operates, the cooling
fan activates automatically to keep the
surfaces of the appliance cool. If you
deactivate the appliance, the cooling fan
can continue to operate until the appliance
cools down.
If there is a defect in the
cooling fan, contact the
Authorised Service Centre.
8.2 Igniting the oven and grill
burners
CAUTION!
When the oven is active, the
lid has to be opened to avoid
over-heating.
Keep the oven door open
when you ignite the burner.
supports are aligned with the centre of
the burner.
7.3 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the hob.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and non-abrasive
detergent. After cleaning, wipe the hob
dry with a soft cloth.
7.4 Cleaning the spark plug
This feature is obtained through a ceramic
ignition candle with a metal electrode.
Keep these components well clean to
prevent difficult lighting and check that the
burner crown holes are not obstructed.
Oven safety device:
The oven burners have a
thermocouple. It stops the
gas flow, if the flame goes
out.
You cannot operate the top
oven burner, when the grill is
active.
1. Open the oven door.
2. Push the knob for the top oven and
turn it counterclockwise to
the top oven burner.
• Push the knob for the top oven
and turn it clockwise to
ignite the grill burner.
• Push the knob for the main oven
and turn it counterclockwise to
to ignite the main oven burner.
3. Keep the knob pushed for equal or
less than 15 seconds to let the
thermocouple warm up. If not, the gas
flow is interrupted.
4. After ignition release the knob, close
the oven door and turn the knob to set
the necessary heat setting.
to ignite
to
Advertisement
Table of Contents
