Table of Contents
Advertisement
10
www.electrolux.com
1. Turn the knob for the hob to the
position
you push the knob, the spark
generator activates automatically.
2. Keep the knob for the hob pushed for
equal or less than 10 seconds to let
the thermocouple warm up. If not, the
gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to light
the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push the
relevant knob down and turn
it to maximum position. Keep
the knob pushed for equal or
less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally
goes out, turn the knob to the
off position and try to light the
burner again after minimum 1
minute.
The spark generator can start
automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
and push it down. When
5.2 Burner overview
I
H
G
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
E) Hob
F) Slots
G) Burner body
H) Location peg
I)
Hole for the ignition candle
5.3 Replacing burner parts
1. Put carefully the burner crown on the
burner body. Let the crown fall freely
onto the body. Do not use force.
Make sure that the hole in the crown
is above the ignition candle.
Make sure that the location pegs are
in the slots in the burner body.
Make sure that you can move the
crown a small distance from side to
side.
2. Put the burner cap centrally on top of
the crown.
Make sure that the cap is correctly
installed, with the enamel side up and
you can move the cap from side to
side and front to back.
3. Light the burner.
If the burner does not ignite, adjust the
crown and cap again.
5.4 Turning the burner off
To put the flame out, turn the knob to the
off position
.
A
B
C
D
E
F
Advertisement
Table of Contents
