Ap Bridge-Point To Point Mode - Edimax EW-7428HCn User Manual

2-4-3 AP Bridge-Point to Point Mode

In this mode, this wireless access point will connect to another wireless
access point which uses the same mode, and all wired Ethernet clients of
both wireless access points will be connected together. You can use this
mode to connect a network to another network which is physically
isolated.
Please note that when you set your access point to this mode, it will not
accept regular wireless clients anymore.
When you select „AP Bridge-Point to Point‟, the following options will
be displayed:
Here are descriptions of every setup item:
Band Please select the wireless band you wish to use. By
selecting different band setting, you‟ll be able to
allow or deny the wireless client of a certain band.
If you select 2.4GHz (B), 2.4GHz (N), or 2.4GHz
(G), only wireless clients using the wireless band
you select (802.11b, 802.11 Draft-N, or 802.11g)
will be able to connect to this access point.
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be
able to connect to this access point.
28