Changing Cooktop And/Or Oven Lights; Adjusting Oven Temperature - Frigidaire FEF455WFBC Owner's Manual

Changing Cooktop and/
or Oven Lights
(some models)
Adjusting Oven
Temperature
Note: The adjustments made will not
change the self-cleaning temperature.
Be sure the oven is unplugged and all parts are COOL before replacing
the oven light. Wear a leather-faced glove for protection against possible broken
glass.
To Change the Cooktop Light
Your model will either have a canopy cover that lifts up or 2 Phillips® Head screws
that secure the light cover. BEFORE CHANGING THE COOKTOP LIGHT, BE SURE TO
TURN THE POWER OFF AT THE MAIN SOURCE OR UNPLUG THE RANGE.
For models with a canopy cover that lifts up, follow these instructions:
1. Grasp the front edge of the canopy cover as illustrated in the side column. Pull
forward and lift the cover up and off toward rear of range.
2. Remove bulb by rolling up and out. Install the new bulb by sliding down into place
and rolling toward front of range.
3. Align front edge of light cover with inside lip of end cap. Lower rear of cover into
place and snap down.
4. Turn power back on at the main source (or plug the range back in).
To Change the Oven Light
The oven light automatically turns on when the door is opened (some models). To
turn the oven light on and off when the door is closed, use the OVEN LIGHT switch
located in the control panel.
1. Turn electrical power off at the main source or unplug the oven.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield in socket and snap wire holder into place.
5. Turn power back on again at the main source (or plug the oven back in).
6. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Owner's Guide.
The temperature in the oven has been set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven is too hot or
too cool, the temperature in the oven can be adjusted. Before adjusting, test a recipe
by using a temperature setting that is higher or lower than the recommended
temperature. The baking results should help you to decide how much of an
adjustment is needed.
To Adjust Oven Temperature:
1. Push BAKE.
2. Set the temperature to 550°F (287°C) by pushing and holding the UP ARROW.
3. Within 15 seconds, push and hold BAKE until the special 2 digit display appears.
Release BAKE. The display now indicates the amount of degrees offset between
the original factory temperature setting and the current temperature setting. If
the oven control has the original factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C) steps,
by pushing and holding the UP or DOWN ARROW. Adjust until the desired
amount of offset appears in the display.
5. When you have made the desired adjustment, push CANCEL to go back to the
time of day display. When adjusting oven temperature, a minus sign (-) will
appear before the number to indicate that the oven will be cooler by the
displayed amount of degrees.
20
(some models)