Changing Cooktop And/Or Oven Lights - Frigidaire FGF376CJSB Owner's Manual

Sealed surface burners electronic oven control- es iv self cleaning oven feature
Hide thumbs Also See for FGF376CJSB:
Table of Contents

Advertisement

General
Cleaning
Figure
1
Figure
2
To Remove
and
Replace
Oven
Bottom
To Remove
Oven Bottom:
1.
Remove
the oven racks.
2.
Remove
the two
hold-down
screws
(Figure
1) at the
rear of the oven
bottom
panel.
If the
screws
are too
tight
to remove
by hand,
use a
screwdriver.
3.
To lift out the bottom
panel, place fingers
in the slots in the bottom.
Lift
the rear of the panel up and back until it is clear of the lip at the front
of
the panel
(Figure
2).
4.
Lift the bottom
up and out.
To Replace
the Oven
Bottom:
1.
Place the oven bottom
in the oven with
the back raised about
6" or until
you can insert the front
of the oven bottom
under the hold-down
lip at the
front
of the panel.
2.
Push the back
of the oven
bottom
down
fully
into
place
on the
metal
flanges
and insert the hold-down
screws.
Changing
Cooktop
and/or Oven Lights
(if equipped)
!
:i /
Be sure the range
is unplugged
and all parts are COOL before
replacing
the surface or oven lights. Wear a leather-faced
glove for protection
against
possible
broken
glass.
To Change
the Cooktop
Light
(some
models)
1.
Turn power
off at the main
source or unplug
the range.
2.
Remove Phillips®
Head screws (2) that secure the light cover and then
lift
the light
cover off.
3.
Remove bulb by rolling
back and up. Install the new bulb by sliding
down
and rolling
forward
into place.
4.
Re-install
light cover and secure with
Phillips®
Head screws (2).
To Change
the Oven
Light
(some
Self
Cleaning
Models)
On some
models,
the
oven
light
automatically
turns
on when
the door
is
opened.
Some models
have a switch
located
on the control
panel to turn on
the light. The oven light
is located
at the rear of the oven and is covered
with
a glass shield held by a wire holder.
The glass shield must be in place whenever
the oven is in use.
To replace
the oven
light:
1.
Turn electrical
power
off at the main
source or unplug
the range.
2.
Press wire holder
to one side to release the glass shield.
3.
Replace bulb with
a new 40 watt
appliance
bulb.
4.
Replace glass shield
over bulb and snap wire holder
into place.
5.
Turn power
back on again at the main source (or plug the range back in).
6.
The clock(if
equipped)
will then need to be reset. To reset, see Setting
the
Clock
and
Minute
Timer
in this Owner's
Guide.
20

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fgf376cjtbFgf376cjbb

Table of Contents