Changing Cooktop And/ Or Oven Lights - Frigidaire FEF365BGDB Owner's Manual

Changing Cooktop and/
or Oven Lights
(some models)
_Be sure the range is
unplugged and all parts are COOL
before replacing the surface or oven
lights. Wear a leather-faced glove for
protection against possible broken glass.
v
To Change the Cooktop Light (some models)
1. Turn power off at the main source or unplug the range.
2. Remove Phillips® Head screws (2) that secure the light cover and then lift the
light cover off.
3. Remove bulb by rolling back and up. Install the new bulb by sliding down and
rolling forward into place.
4. Re-install light cover and secure with Phillips® Head screws (2).
To Change the Oven Light (some models)
On some models, the oven light automatically turns on when the door is opened.
Some models have a switch located on the control panel to turn on the light. The
oven light is located at the rear of the oven and is covered with a glass shield held
by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Presswire holderto one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock(if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner's Guide.
Adjusting Oven
Temperature
Note: The adjustments made will not
change the self-cleaning temperature.
The temperature in the oven has been set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven is too hot or
too cool, the temperature in the oven can be adjusted. Before adjusting, test a recipe
by using a temperature setting that is higher or lower than the recommended
temperature. The baking results should help you to decide how much of an
adjustment is needed.
To Adjust Oven Temperature:
1. Push BAKE.
2. Set the temperature to 550°F (287°C) by pushing and holding theUP ARROW.
3. Within 2 seconds, push and hold BAKE until the special 2 digit display appears.
Release BAKE. The display now indicates the amount of degrees offset
between the original factory temperature setting and the current temperature
setting. If the oven control has the original factory calibration, the display will
read "00."
4. The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C)
steps, by pushing and holding the UP or DOWN ARROW. Adjust until the
desired amount of offset appears in the display.
5. When you have made the desired adjustment, pushCANCELto go back to the
time of day display. When adjusting oven temperature, a minus sign (-) will
appear before the number to indicate that the oven will be cooler by the
displayed amount of degrees.
19