Panasonic WH-MHF12G9E8 Service Manual page 44

B. If Remote Control Cable Is Exposed
1 Install the remote control lower case to the
wall with the two accessory screws (4).
2 Fasten the screws properly until screw head is
lower than the rib and reach the base of
remote control lower case to ensure they do
not damage the PCB inside the remote control
(1).
Wall
Rib
Screw (4)
Remote
control lower
case
3 The feeding-out direction for the remote
control cable can be either via top, left or right
side.
11.4.6 Connecting The Remote Control Cable To Mono Bloc Unit
Be sure to turn off the main power before installing and
connecting the remote control. Otherwise, it will cause the
electrical shock.
1 Remove the cabinet front plate.
2 Connect the remote control cable with the
provided connector as shown in below
illustration. (Refer wiring diagram for detail.)
3 Guide the remote control cable through the
clamper and Bushing .
(Refer illustration "How to connect Remote
Control to Provided Connector" for detail.)
4 Reinstall the cabinet front plate after
connection complete.
Remote control cable (2)
Upper case
Upper tab
Connector (CON1)
Lower case
Screw (4)
Lower tab
WARNING
4 Use nipper to cut a notch at the upper case.
(Select the intended feeding-out position)
5 Route the remote control cable (2) inside the
lower case in accordance with the intended
feeding-out direction. (Refer to the illustration
at below)
6 Insert firmly the connector of remote control
cable (2) to connector (CON1) in the upper
case circuit board. (Refer to the illustration at
below)
Wall
7 Secure the remote control upper case to the
lower case with the tabs provided.
Top feeding-out
position
Left
feeding-
out
Right
position
feeding-
out
Lower
case
Remove this dummy connector
cap first, before plug in
PCB
Connect the wired remote
control cable with the connector
provided here
How to connect Remote Control to Provided
44
Remote
Notches
control
cable (2)
Connector
(CON1)
Upper case
Upper case
Tabs
Lower case
Remote
Control
Connector
Plug in firmly
Provided
Connector
Clamp the wired
remote control cable
with clamper.
Wired remote
control cable
Bind the wired
remote control
cable and all
power supply
cords to the tube
with band strap
(field supply)
Bushing
Connector
Remote
control
7
Apply cut