LG LDG4313BD Service Manual page 61

30” freestanding gas double oven range
Hide thumbs Also See for LDG4313BD:
Table of Contents

Advertisement

Symptoms and Questions
Fan noise
Fan and burner operating in the oven
at normal bake
Burners are not lighting properly after
cleaning the cooktop surface.
When lighting just one burner,
clicking noise is heard from all the
burners.
My range is still dirty after running
the EasyClean® cycle. What else
should I do?
I tried scrubbing my oven after
running EasyClean®, but some soils
still remain. What can I do?
Soils on my oven walls are not
coming off. How can I get my walls
clean?
Will EasyClean® get all of the soils
and stains out completely?
Are there any tricks to getting some
of the stubborn soils out?
Is it safe for water to spill into the
oven bottom vents during cleaning?
TROUBLESHOOTING
• A convection fan may automatically turn on and off.
- This is normal.
It is normal for the fan to run while preheating during a regular bake cycle.
The fan motor may run periodically during a regular bake cycle. This is to
ensure even baking results.
The bake burner turns off if the door is left open during baking.
If the door is left open for longer than 30 seconds during baking, the bake
burner turns off. The bake burner turns back on automatically once the
door is closed.
Make sure that the burner heads and caps are completely dry and
properly positioned.
This is normal. Electric spark igniters from the burners cause the clicking
noise. All the spark igniters on the cooktop will activate when igniting just
one burner.
The EasyClean® cycle only helps to loosen light soils in your oven range
to assist in hand-cleaning of your oven. It does not automatically remove
all soils after the cycle. Some scrubbing of your oven range is required
after running the EasyClean® cycle.
EasyClean® feature works best when the soils are fully soaked and
submerged in water before running the cycle. If soils are not sufficiently
soaked in water, it can negatively affect cleaning performance. Repeat the
EasyClean® process using sufficient water. Sugar-based and certain
grease soils are especially hard to clean. If some stubborn soils remain,
use the Self Clean feature to thoroughly clean your oven.
Soils on the side and rear walls of your oven range may be more difficult
to fully soak with water. Repeat the EasyClean® process with more than
the 1/4 cup (2 oz) spray recommended.
It depends on the soil type. Sugar-based and certain grease stains are
especially hard to clean. Also, if stains are not sufficiently soaked in water,
then this can also negatively affect cleaning performance. If stubborn or
built-up stains remain, use the Self Clean feature. Refer to the Self Clean
section of your owner's manual.
Scraping the soils with a plastic scraper before and during handcleaning
cleaning is recommended. Fully saturating soils with water is also
recommended. However, certain types of soils are harder to clean than
others. For these stubborn soils, the
Self Clean cycle is recommended. Consult the Self Clean section of your
owner's manual for details.
Some water spillage into the oven bottom vents (gas range) is okay.
However, it is recommended to try avoid spilling too much water into the
vents.
8-5
Possible Cause/Solution

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ldg4313stLdg4315bdLdg4315st

Table of Contents