Preparing For Installation - SignitePro CA30000 Manual

PREPARING FOR INSTALLATION

Before beginning assembly or operation of the product, make sure all parts are present.
Compare parts with package contents list. If any part is missing or damaged, do not attempt
to assemble, install or operate the product. Contact customer service for replacement parts.
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging applied to heater for shipping.
3. Verify all contents are present.
4. If legs purchased separately, accessory bag contains:
Mounting Bracket × 1, Wood Screw (4x50) x 4, Screw (4.8x25) x 2, AAA Battery x 1,
Rawl Plugs × 4, Spacer x 2
5. Leg mount kit contains: Screw(3.9×13) × 4, Support Leg × 2
6. Check heater for any shipping damage. If heater is damaged, inform dealer immediately
Mounting
Bracket×1
AAA Battery×1
WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS
Water vapor is a by-product of gas combustion. An unvented room heater produces approximately
one (1) ounce (30 mL) of water for every 1,000 BTU (.3 Kw) of gas input per hour. An unvented room
heater is intended as a supplemental heater rather than a primary heat source. In most supplemental
heat applications, the water vapor does not create a problem.
In most applications, the water vapor enhances the low humidity atmosphere experienced during cold
weather. The following steps will help ensure that water vapor does not become a problem:
1. Be sure the heater is the proper size for the application, including adequate combustion air and
circulation air.
2. If there is high humidity, a dehumidifier may be used to help lower the water vapor content of
the air.
3. Do not use an unvented room heater as the primary heat source.
Accessory bag
Wood Screw
(4×50)×4
Rawl Plug×4
Screw ST
(4.8×25)×2
Spacer×2
6
Leg Mount Kit (Optional)
Screw ST
(3.9×13)×4
Support Leg×2