Table of Contents
Advertisement
Quick Links
DO NOT REMOVE THESE TAGS
When used without adequate combustion and ventilation air,
heater may give off excessive CARBON MONOXIDE, an
odorless, poisonous gas.
DO NOT INSTALL UNTIL ALL NECESSARY PROVISIONS ARE MADE
FOR COMBUSTION AND VENTILATION AIR. CONSULT THE WRITTEN
INSTRUCTIONS PROVIDED WITH THE HEATER FOR INFORMATION
CONCERNING COMBUSTION AND VENTILATION AIR. IN THE ABSENCE
OF INSTRUCTIONS REFER TO THE NATIONAL FUEL GAS CODE, ANSI
Z223.1/NFPA 54, AIR FOR COMBUSTION AND VENTILATION, OR
APPLICABLE LOCAL CODES.
This heater is equipped with a PILOT LIGHT SAFETY SYSTEM
designed to turn off the heater if not enough fresh air is available.
DO NOT TAMPER WITH PILOT LIGHT SAFETY SYSTEM!
If heater shuts off, do not relight until you provide fresh air.
CARBON MONOXIDE POISONING MAY LEAD TO DEATH.
If heater keeps shutting off, have it serviced. Keep burner and control
compartment clean.
Early signs of carbon monoxide poisoning resemble the flu with headaches,
dizziness and/or nausea. If you have these signs, heater may not be working
properly. Get fresh air at once! Have heater serviced.
Some people - pregnant women, persons with heart or lung disease, anemia,
those under the influence of alcohol, those at high altitudes - are more affected by
carbon monoxide poisoning than others.
WARNING
CA-529-
1
2019-11-15
Advertisement
Table of Contents
Related Manuals for SignitePro CA30000BL
Summary of Contents for SignitePro CA30000BL
- Page 1 DO NOT REMOVE THESE TAGS WARNING When used without adequate combustion and ventilation air, heater may give off excessive CARBON MONOXIDE, an odorless, poisonous gas. DO NOT INSTALL UNTIL ALL NECESSARY PROVISIONS ARE MADE FOR COMBUSTION AND VENTILATION AIR. CONSULT THE WRITTEN INSTRUCTIONS PROVIDED WITH THE HEATER FOR INFORMATION CONCERNING COMBUSTION AND VENTILATION AIR.
- Page 2 WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause property damage, personal injury, or loss of life. Refer to the owner’s information manual provided with this appliance. Installation and service must be performed by a qualified installer, service agency, or gas supplier Removal of this marking will void the compliance of this heater with ANSI Z21.11.2.
- Page 3 LIGHTING INSTRUCTIONS Thermostat Models 1. STOP! Read the safety information on the previous tag. Ignitor 2. Turn off all electric power to the appliance. Control Knob 3. Turn control knob clockwise to the “OFF” position. 4. Wait (5) minutes to clear out any gas. Then smell for gas, including near the floor.
- Page 4 Fig. 1 - Correct Pilot Flame Pattern Fig. 2 - Incorrect Pilot Flame Pattern Infrared model Infrared model Fig. 3 - Correct Pilot Flame Pattern Fig. 4 - Incorrect Pilot Flame Pattern Blue Flame model Blue Flame model Fig. 5 - Correct/Normal Flame Pattern Fig.
- Page 5 WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury. See instruction manual for further information. Rawl plug (x4) Bracket Screw(x4) Spacer Screw(x2)
- Page 6 Model CA30000BL CA30000CL CA30000B CA30000C Input Type 30,000 BTU 30,000 BTU 30,000 BTU 30,000 BTU Gas Type Manifold Pressure 10” WC 10” WC 5” WC 5” WC Max. Inlet Pressure 14” WC 14” WC 9” WC 9” WC Min. Inlet Pressure 11”...
Need help?
Do you have a question about the CA30000BL and is the answer not in the manual?
Questions and answers