Viscosity Table; Troubleshooting Guide - EINHELL TC-SY 18/60 Li Original Operating Instructions

10. Viscosity Table

Examples of spray materials. Follow the
manufacturer's instructions!
Solvent-borne primers
Solvent-borne paint
Water-borne primers
Water-borne paint
Wood preservatives, stains, oils
Disinfectants
Vehicle topcoats

11. Troubleshooting Guide

Fault
No material exits from the
nozzle
Material drips from nozzle
after spraying
Atomization too coarse
Intermittent ("fl uttering")
spray
Coating pattern is too
light and uneven
The paint runs
Excessive spray mist
Anl_TC_SY_18_60_Li_SPK7_USA.indb 17 Anl_TC_SY_18_60_Li_SPK7_USA.indb 17
EN
Draining time in seconds (DIN-sec)
25-30
15-30
25-30
20-25
undiluted
undiluted
20-25
Possible cause
- Nozzle clogged.
- Material tube clogged.
- Max. paint volume control rotated too far
anti-clockwise (-).
- Material tube is loose.
- No pressure build-up in the container.
- Consistency of the material is too thick.
- Nozzle is loose.
- Nozzle is worn.
- Nozzle seal is worn.
- Solids in the air cap or nozzle.
- Material viscosity too high.
- Material volume too high.
- Max. paint volume control turned too far
clockwise (+).
- Dirty nozzle.
- Insuffi cient pressure build-up in the
container
- Almost all of the material in the container
has been used up.
- You moved the paint spray gun too fast
across the surface you are working on.
- You applied too much material
- The gun is too far away from the object
you are working on
- 17 -
Remedy
- Clean
- Clean
- Turn clockwise (+)
- Insert
- Tighten container
- Dilute
- Tighten
- Replace
- Replace
- Clean
- Dilute
- Turn the max. paint
volume control anti-
clockwise (-)
- Clean
- Tighten the container
- Add more
- Move the gun more
slowly
- Turn the max. paint
volume control anti-
clockwise (-)
- Hold the gun closer
- Turn the max. paint
volume control anti-
clockwise (-)
25.08.2021 15:06:05 25.08.2021 15:06:05