Table of Contents
Advertisement
Adjusting the telephone settings
Setting the display backlight
The display backlight is always lit when the handset is not in the base/charging cradle or when
a key is pressed. Any digit keys pressed appear on the display for pre-dialling.
Ï
You can also activate/deactivate the display backlight for idle status:
v
¤
¤
¤
q Display
OK
In Charger: r On / Off
Out of Charger: r On / Off
¤
Save
Note
The handset's standby time can be significantly reduced if the display backlight is activated.
Activating/deactivating Message key flashing
Specify whether receipt of new messages should be displayed on the handset by the message
LED.
¤
In idle status: v
The display shows the number 9.
¤
Press the following keys to select the type of message:
M4
for messages on the network mailbox
M5
for missed calls
MM
for messages on the answer machine
(only CL540A)
You will see the number 9 followed by your entry (e.g. 975);
the current setting will be flashing in the entry field (e.g. 0).
¤
Press the key Q or
to determine the setting for new
messages:
Q
The Message key flashes
(stops when the key is pressed)
The Message key does not flash
¤
Confirm by pressing OK or go back to the idle display without saving by pressing Back.
Activating/deactivating Auto Answer
When set to Auto Answer, the handset accepts an incoming call as soon as you remove it from
Ï
the charging cradle.
v
¤
¤
¤
q Telephony
OK
Regardless of the setting Auto Answer, the connection ends as soon as you place the handset
back in the charging cradle. Exception: Press and hold c for a further 2 seconds while placing
the handset in the charging cradle.
28
¤
¤
OK
¤
*#Q5#
¤
OK
q Backlight
¤
OK
¤
¤
Auto Answer
Change (³ = activated)
System
975 SET:
[0]
Back
OK
Advertisement
Table of Contents
