Mio A702 User Manual page 14

Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
For body worn operation, this phone has been tested and meets the FCC RF
exposure guidelines for use with an accessory that contains no metal and the
positions the handset a minimum of 1.5 cm from the body. Use of other
enhancements may not ensure compliance with FCC RF exposure
guidelines. If you do no t use a body-worn accessory and are not holding
the phone at the ear, position the handset a minimum of 1.5 cm from your
body when the phone is switched on.
The highest FCC SAR value for this device when tested for use at the head
is 0.857 W/kg and when tested for use at the body is 1.205W/kg.
European Notice
Products with the CE marking comply with Radio & Telecommunication
Terminal Equipment Directive (R&TTE) (1999/5/EEC), the
Electromagnetic Compatibility Directive (89/336/EEC) and the Low
Voltage Directive (73/23/EEC) – as amended by Directive 93/68/ECC -
issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following
European Standards:
1999/5/EEC Radio & Telecommunication Terminal Equipment Directive
(R&TTE)
EN 301 511 / EN 300 328
Specific Absorption Rate (SAR)
Standard: EN 50360, EN 50361
73/23/EEC Low Voltage Directive (LVD)
IEC 60950-1:2001 89/336/EEC Electromagnetic
Compatibility (EMC-Directive)
Standard: EN 301489-1/7/17