Table of Contents
Advertisement
Available languages
Available languages
To Assemble The Creaming
Beater
Refer to Illustrations
Fitting The Wiper Blade
The wiper blade is supplied already
fitted and should always be removed
before cleaning.
1
Carefully fit the flexible wiper blade
onto the tool by locating the base
of the wiper blade into the slot then
fit one side into the groove before
gently hooking the end in place.
Repeat with the other side.
To Use Your Bowl Bright™
(In-Bowl Illumination)
Your Stand Mixer is fitted with an in-
bowl illumination feature located on
the underside of the mixer head.
To turn the in bowl illumination off,
select BowlBright™ in the settings
menu and select off.
Note: The in bowl illumination will
automatically activate when the machine
is switched on.
To Remove And Fit Outlet
Covers
High-speed Outlet Cover
1
To remove the cover, use the grip on
the side and lift upwards.
2
To fit, place the cover over the outlet
and drop into place.
Slow-speed Outlet Cover
1
To remove the cover, use the grip on
the top and pull outwards.
2
To fit, place the cover over the outlet
and push into place.
901603 G20M
P
R
–
To Fit And Use Your
Splashguard
Refer to Illustrations
Note: The splashguard is suitable for use
with the 7L bowl only.
To assemble
The splashguard assembly consists of
2 pieces: the head shield
splashguard
.
The splashguard cannot be fitted to the
bowl unless the shield is fitted.
1
Raise the mixer head until it locks.
2
Clip the head shield upwards onto
the underside of the mixer head until
fully located.
3
Fit the bowl onto the base.
4
Lower the mixer head.
5
Rest the splashguard on the bowl
rim and then slide forward until fully
located.
During mixing, ingredients can be
added directly to the bowl via the
feed chute.
6
To remove the splashguard simply
slide it away from the mixer bowl.
7
To remove the head shield, raise the
mixer head until it locks. Remove the
tool if fitted, then pull the head shield
downwards from the underside of
the mixer head.
Note: Only fit or remove the splashguard
when the mixer head is in the locked
position.
We recommend that the head shield is
removed regularly from the mixer head
for cleaning.
12
S
T
–
and the
Advertisement
Table of Contents
