Elation KL PAR FC User Manual page 11

FIXTURE INSTALLATION
CLAMP INSTALLATION
This device features a mounting clamp attachment point built into the mounting bracket, as well as
two safety cable attachment points located on the rear face of the fixture on either side of the con-
trol panel (see the illustration below). When mounting the fixture to a truss or any other suspended
or overhead installation, be sure to secure an appropriately rated clamp (not included) to the clamp
attachment point and attach a separate SAFETY CABLE of the appropriate safety rating to the safe-
ty cable rigging point.
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE IN A
SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL NOT FALL IF
THE CLAMP FAILS.
RIGGING
Overhead rigging requires extensive experience, including but not limited to: calculating working
load limits, understanding the installation material being used, and periodic safety inspection of all
installation material and the fixture itself. If you lack these qualifications, do not attempt to perform
the installation yourself. Improper installation can result in bodily injury.
11