Advertisement
Quick Links
Assembly Instruction Manual
MODEL NO.: DONATA1800
www.rvm.com.au
128 -192
- Please follow these assembly instructions as it will save you time, make
assembly easier and prevent possible damage to your new unit.
- We strongly recommend that the unit is assembled on a soft surface such
as carpet or blanket.
as power tools can strip threads if over tightened.
- Correct assembly is your responsibility.
- When moving this furniture item, always carry the unit. Dragging or
sliding the unit could damage the unit and the floor surface.
Advertisement
Related Manuals for Tauris DONATA1800
Summary of Contents for Tauris DONATA1800
- Page 1 Assembly Instruction Manual MODEL NO.: DONATA1800 www.rvm.com.au 128 -192 - Please follow these assembly instructions as it will save you time, make assembly easier and prevent possible damage to your new unit. - We strongly recommend that the unit is assembled on a soft surface such as carpet or blanket.
- Page 2 SMALL SHELF CABLE MANAGEMENT BASE FRONT LEG FRAME LEG CROSSMEMBER REAR LEG FRAME LEFT DRAWER PANEL RIGHT DRAWER PANEL REAR DRAWER PANEL DRAWER CROSSMEMBER DRAWER BASE LEFT DRAWER FRONT RIGHT DRAWER FRONT LARGE SHELF LEFT DOOR RIGHT DOOR ANTI-TIPPING MECHANISM ANTI-TIPPING MECHANISM ANTI-TIPPING MECHANISM ANTI-TIPPING MECHANISM...
- Page 3 OVERVIEW...
- Page 4 1. HAND TIGHTEN THREADED BAR(29) INTO THE LEG FITTING FIRST 2. SLIDE CROSS RAIL(10) ONTO THREADED BAR(29) 3. TIGHTEN NUTS WITH THE SPANER PROVIDED(30) arrowhead on cam points toward to the hole on the panel edge.
- Page 5 arrowhead on cam points toward to the hole on the panel edge.
- Page 6 arrowhead on cam points toward to the hole on the panel edge. MAKE SURE THAT THE CABLE MANAGEMENT HOLES ARE POSITIONED AS SHOWN...
- Page 8 AFTER THIS STEP IS COMPLETE, ROLL THE CABINET OVER ONTO ITS FEET.
- Page 10 NOTE: For gyprock walls ensure you locate the studs, or use appropriate to the wall. (also see Step 14) Use a screw driver to fasten the screws (Part 25) into the wall.
- Page 11 Use a screw driver to fasten the screws (Part 39) into the bracket.
- Page 12 Drawer Front Alignment Drawer front panel If the drawer front panel is NOT level after being assembled, then... Drawer front panel Drawer Side Drawer Runner Loosen the screw Adjust the slide up or down Loosen the screws on the left and right hand side, then move the drawer slide up or down, untill the drawer fronts are even/level, then tighten the screws...
- Page 13 COPY OF YOUR PURCHASE SLIP/RECEIPT MODEL NUMBER OF THE UNIT PURCHASED DESCRIPTION/PART NUMBER OF THE MISSING OR FAULTY PART QUANTITY OF THE PARTS NEEDED If for whatever reason you cannot contact the store, please contact Tauris direct at http://www.rvm.com.au/contact. Product of: RVM Australia...
- Page 14 You are also en tled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Tauris 2. Subject to Clause 1, the Seller warrants that branded products will be free of manufacturing defects and will perform to the Seller’s speci ca ons subject to the following...
- Page 15 7. The seller will examine any returned Products and if the Seller determines that there is an apparent defect through no fault of the Owner, the Seller will: a.) Make note of the Owner’s contact details including the Owner’s telephone number which the owner can be contacted during business hours, postal address and e-mail address.