Advertisement
Quick Links
www.rvm.com.au
- Please follow these assembly instructions as it will save you time, make
assembly easier and prevent possible damage to your new unit.
- We strongly recommend that the unit is assembled on a soft surface such
as carpet or blanket.
as power tools can strip threads if over tightened.
- Correct assembly is your responsibility.
- When moving this furniture item, always carry the unit. Dragging or
sliding the unit could damage the unit and the floor surface.
Assembly Instruction Manual
MODEL NO.: NOVA2000LL
Advertisement
Related Manuals for Tauris NOVA2000LL
Summary of Contents for Tauris NOVA2000LL
- Page 1 Assembly Instruction Manual MODEL NO.: NOVA2000LL www.rvm.com.au - Please follow these assembly instructions as it will save you time, make assembly easier and prevent possible damage to your new unit. - We strongly recommend that the unit is assembled on a soft surface such as carpet or blanket.
- Page 2 NOTE: PLEASE CHECK YOU HAVE ALL THE CORRECT PARTS LISTED BELOW BEFORE YOU START ASSEMBLING YOUR TV CABINET Center Support Left Hand Right Hand Left Hand Right Hand 9 x 1pc 10 x 1pc Cable Management Base Front Leg Rear Leg Cross Rail Drawer Back Left drawer side...
- Page 3 OVERVIEW...
- Page 4 18 x 2pcs 19 x 2pcs arrowhead on cam points toward to the hole on the panel edge. 18 x 8pcs 19 x 8pcs 20 x 8pcs 21 x 3pcs arrowhead on cam points toward to the hole on the panel edge.
- Page 5 22 x 8pcs 20 x 8pcs...
- Page 6 1. HAND TIGHTEN THREADED BAR(26) INTO THE LEG FITTING FIRST 2. SLIDE CROSS RAIL(11) ONTO THREADED BAR(26) 3. TIGHTEN NUTS WITH THE SPANNER PROVIDED(27) 28 x 8pcs...
- Page 7 (2 DRAWERS) 18 x 10pcs 19 x 10pcs 22 x 10pcs arrowhead on cam points toward to the hole on the panel edge.
- Page 8 23 x 4pcs...
- Page 9 Drawer Front Alignment Drawer front panel If the drawer front panel is NOT level after being assembled, then... Drawer front panel Drawer Side Drawer Runner Loosen the screw Adjust the slide up or down Loosen the screws on the left and right hand side, then move the drawer slide up or down, untill the drawer fronts are even/level, then tighten the screws...
- Page 10 COPY OF YOUR PURCHASE SLIP/RECEIPT MODEL NUMBER OF THE UNIT PURCHASED DESCRIPTION/PART NUMBER OF THE MISSING OR FAULTY PART QUANTITY OF THE PARTS NEEDED If for whatever reason you cannot contact the store, please contact Tauris direct at http://www.rvm.com.au/contact. Product of: RVM Australia...
- Page 11 You are also en tled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Tauris 2. Subject to Clause 1, the Seller warrants that branded products will be free of manufacturing defects and will perform to the Seller’s speci ca ons subject to the following...
- Page 12 7. The seller will examine any returned Products and if the Seller determines that there is an apparent defect through no fault of the Owner, the Seller will: a.) Make note of the Owner’s contact details including the Owner’s telephone number which the owner can be contacted during business hours, postal address and e-mail address.