Vermont Castings VC41LDVINTSC Installation And Operating Instructions Manual page 18

Clean face direct vent fireplace insert
Table of Contents

Advertisement

VC41LDVI/VC41CDVI Gas Fireplace Insert
Only persons licensed to work with gas
piping may make the necessary gas con-
nections to this appliance.
NOTe : The gas line connection may be made using
1/2" rigid tubing or an approved flex connector. Since
some municipalities have additional local codes it
is always best to consult your local authorities and
the current edition of the National Fuel Gas Code
ANSI.Z223.1, NFPA54. In Canada CSA-B149 (1 or 2)
Installation Code.
A listed manual shutoff is factory installed upstream of
appliance. Union tee and plugged 1/8" NPT pressure tap-
ping point should be installed upstream of the appliance.
Figure 19
IMPORTANT: The main gas valve is for turning on or
shutting off the gas to the insert.
Check your building codes for any special requirements
for locating equipment shutoff valve to inserts.
Apply pipe joint sealant lightly to threads. This will pre-
vent excess sealant from going into pipe. Excess sealant
in pipe could result in clogged burner system valves.
18
Approved Flexible
Gas Line Supplied
with Appliance
Figure 19 -
Gas Connection
FP1931
gas connection
9/08
A manual shut-off valve is factory installed
upstream of the appliance. union tee and
plugged 1/8" NPT pressure tapping point
should be installed upstream of the appli-
ance. Figure 19
We recommend that you install a sediment trap/drip leg in
supply line as shown in Figure 19. Locate sediment trap/drip
leg where it is within reach for cleaning. Install in piping
system between fuel supply and burner system. Locate
sediment trap/drip leg where trapped matter is not likely to
freeze. A sediment trap traps moisture and contaminants.
This keeps them from going into the burner system gas con-
trols. If sediment trap/drip leg is not installed or is installed
wrong, burner system may not run properly.
use pipe joint sealant that is resistant to
liquid petroleum (LP) gas.
Tee Joint
Pipe Nipple
Cap
INSTALLATION
3 "
M i
n i m
u m
Natural Gas
From Gas Meter
(4.5" w.c. to 10.5" w.c. Pressure)
Propane/LP
From External Regulator
(11" w.c. to 13" w.c. Pressure)
20304685

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vc41ldviptscVc41cdvintscVc41ldvi

Table of Contents