Table of Contents
Advertisement
Configuring the NI 1411
After you have installed the NI 1411 and powered on the computer, the computer will recognize the
device and assign resources to it. Use Measurement & Automation Explorer (MAX), the National
Instruments configuration utility, to configure the NI 1411 for acquisition. Refer to the Measurement &
Automation Explorer Help for NI-IMAQ for additional information about configuring the NI 1411.
Note
Before configuring the device in MAX, ensure that you installed the NI-IMAQ driver
software.
Specifications
The following specifications apply to the NI 1411 image acquisition device. These specifications are
typical at 25 °C unless otherwise specified.
Formats Supported
Input formats
RS-170/NTSC................................................29.97 frames/s
CCIR/PAL......................................................25 frames/s
Output formats
RGB ..............................................................32-bit
HSL................................................................32-bit
R, G, B, H, S, or L .........................................8-bit
Pixel aspect ratio ............................................Square pixel
Video Input
Quantity .................................................................1 (VIDEO)
VIDEO ...................................................................Composite video on BNC (RSE), Y/C on S-Video
Input impedance.....................................................75 Ω ± 1%
Input range (blank to white)...................................700 mV (calibrated) or
Frequency response (luminance)
Full range .......................................................12 MHz (–3 dB) typ
Programmable................................................Decimation and lowpass filters
© National Instruments Corporation
connector (RSE)
400 mV to 1.00 V (variable gain)
(PCI-1411 revision C and later,
PXI-1411 revision A and later)
(all filters off)
5
Getting Started with the NI PXI/PCI-1411
Advertisement
Table of Contents
