Advertisement
Procedure:
1. Turn off the E5250A, then wait at least 10 seconds before you remove or install
a card.
2. Remove blank panel or card from the slot where you want to install the new card
as follows:
•
To remove blank panel, do as follows:
Loosen the screws on both the left and right edges of the blank panel by
using the wrench furnished with the E5252A, then remove the blank panel.
•
To remove a card, do as follows:
a. Screw the Module Extractor into the screw hole for the extractor. See
figure below. Module Extractor is furnished with the E5250A.
b. Loosen the screws on left and right edges of the card by using the wrench
furnished with the E5252A.
c. Gently pull the Module Extractor to extract the card from the card slot.
Module Extractor and Location of the Screw Hole
#IKNGPV '#
3. Install the card as follows:
a. Align the card with the left and right slot guide rails. The component side
should be facing up.
b. Push the card into the slot until you feel it seat firmly into the connector at
the back of the card slot.
c. Screw in the screws on the left and right edges of the card by using the
wrench furnished with the E5252A.
Agilent E5252A Installation Guide, Edition 2
5ETGY *QNG
HQT /QFWNG
'ZVTCEVQT
/QFWNG
'ZVTCEVQT
9
Advertisement
