Quadratec Q Series Assembly And Installation Manual page 4

Assembly and Installation Continued)
When the solenoid is mounted to the top of the tie bars, the winch power cables MUST
be PROPERLY placed to the OUTSIDE of the rear tie bar as shown. Power cables MUST
NOT come in contact with a rotating winch cable assembly or power cable insulation
MAY be compromised and short circuit. Improper placement of power cables MAY
result in damage to the winch or the vehicle.
Solenoid (Top Mount) Installation
Tapped holes to the rear tie bar.
Tighten using
a 10mm wrench.
Photo D
Attach solenoid pack to the top mount brackets
using a flat washer, split lock washer and nut for
each of the four studs.
Photo D. Note the relationship between
the solenoid pack and the top mount
brackets. Place a flat washer, lock washer
and nut onto each stud and tighten with
a10mm wrench.
Tie Bar
Cable
Assembly
Photo E
Tighten using a
P2 phillips head
screw driver.
Attach the solenoid pack with mount brackets to
tie bars using a phillips head screw with split lock
washer.
Photo E. Center the solenoid pack onto
the winch tie bars and fasten with two
phillips head machine screws with split
lock washers to attach the brackets.
There is a tapped hole on each of the
brackets. Tighten both screws using a P2
phillips head screwdriver.
Power Cables From
Coming into Contact with
The Trusted Source
4
Be Sure to Keep
Cable Assembly