Quadratec Q Series Assembly And Installation Manual page 3

Assembly and Installation:
Attach the solenoid pack to the side mount
solenoid bracket using a flat washer, split
lock washer and nut for each
of the four studs. Tighten
using a 10mm wrench.
Solenoid (Side Mount) Installation
Photo A. Carefully study the relationship
between the solenoid pack and the side
mount bracket. Run the four cables and
black thermal relay ground wire through
the bracket along with the four mounting
studs as shown. Place a flat washer, lock
washer and nut onto each stud and
tighten with a 10mm wrench.
Photo C. Fasten a machine screw with a
split lock washer followed by a flat
washer. Tighten all three solenoid mount
fasteners now.
Q-Series Winches feature two mounting
positions to suit your
applications. The Above Side Mount
Installation features a Heavy Duty
Solenoid Bracket (Shown Right). Some
bumpers with Grille Guards or Tubular
Hoops require the Q-Series Winch to Be
installed using the Top Mount Solenoid
Brackets. To install Winch with Top Mount
Bracket, please refer to page 4 for
Installation.
Photo B
Photo A
Tighten both 6mm x 1mm x 12 mm
screws using a 5mm hex key.
Photo B. Fasten two socket cap screws
with split lock washer and flat washer to
attach the bracket to the winch base.
There are tapped holes on each side of the
motor mount. Do not tighten until the
third fastener is in place.
individual
Tighten the third 5mm x 8mm x 12mm
screw using a P2 Phillips Screw Driver.
The Trusted Source
3
Photo C