Air Flow Velocity And Direction Adjustment - Mitsubishi Electric MSC-09RV Operating Instructions Manual

AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT

AIR FLOW velocity and direction can be selected
as required.
˚C
CLOCK
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
FAN STOP
I FEEL COOL
VANE START
HEAT
DRY
/FAN
MODE HR.
ECONO COOL MIN.
RESET CLOCK
I
To change the AIR FLOW velocity, press
FAN
the button.
Each time the button is pressed, the fan speed is
changed in sequence: (Lo) → → → → → (Med) → → → → →
(AUTO)
•
Use the (Hi) notch to cool/heat the room more.
•
If the operating sound of the air conditioner disturbs your
sleep, use the (Lo) notch.
I
To change the AIR FLOW blowing direc-
VANE
tion vertically, press the button.
Each time the button is pressed, the angle of the hori-
zontal vane is changed in sequence:
→ → → → → (3) → → → → → (4) → → → → → (5) → → → → → (SWING) → → → → →
SWING OPERATION
Use the swing operation for the air flow to reach all corners
of the room.
Recommended horizontal vane
range
COOL
Use the (AUTO) position usu- DRY
ally.
Use position (1) or (2) in the
COOL or DRY mode and use posi-
HEAT
tions (3) to (5) in the HEAT
mode when adjusting to your re-
quirements.
NOTE
I In the cooling operation, when the air conditioner is op-
erated with setting the horizontal vane to
for 1 hour, the AIR FLOW direction is automatically set
to horizontal to prevent condensed water from dropping.
I Adjust the vertical AIR FLOW direction using the remote
controller. If the horizontal vane is moved manually, it
may cause trouble.
I In the heating operation, if the air flow temperature is
too low or when defrosting is being done, the horizontal
vane position is set to (1).
Auto air flow direction control operation
I When the AUTO mode is selected with the
(Hi) → → → → →
to correspond to the operation mode for effective operation.
(1) HEAT
When the air flow temperature is too low,
the air is blown out horizontally.
(1) → → → → →
(2)
(AUTO)
(2) COOL, DRY
The air is blown out horizontally.
1
2
3
4
I
To change the horizontal direction of the air flow, move the vertical vane manu-
5
ally.
(4) or (5)
Adjust the vane before operation starts.
Since the horizontal vane moves automatically, your fingers may be caught.
VANE
button, the position of the horizontal vane is automatically set
When the air flow temperature rises,
the air is blown out downwards.
(3) FAN
The air is blown out downwards.
11