I Feel - Mitsubishi Electric MSC-09RV Operating Instructions Manual

I FEEL... AUTO OPERATION
With the " (I FEEL...)" auto operation mode,
the optimum room condition can be set automati-
cally with a one-touch operation.
˚C
CLOCK
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
FAN STOP
I FEEL COOL
VANE START
HEAT
DRY
/FAN
MODE HR.
ECONO COOL MIN.
RESET CLOCK
•
To start operation:
I
ON/OFF
Press the button.
When the " (I FEEL...)" mode is selected, the air
conditioner is automatically controlled at the optimum
temperature.
•
To stop operation:
I
ON/OFF
Press the button.
•
If you feel slightly warm:
I TOO
WARM
Press the button to lower the tempera-
ture.
One press lowers the temperature by about 1
•
If you feel slightly cool:
I TOO
COOL
Press the button to raise the tempera-
ture.
One press raises the temperature by about 1
When " (I FEEL...)" is not selected, press the
MODE
button until it is set.
Each time the button is pressed, the operation mode is
(I FEEL...) → → → → → (COOL) → → → → →
changed in sequence:
→ → → → →
(HEAT/FAN)
FAN STOP
I FEEL COOL
VANE START
HEAT
DRY
/FAN
MODE HR.
ECONO COOL MIN
Description of "I FEEL..." mode
Details of operation
According to the room temperature when the operation starts,
the operation mode is automatically set to COOL, DRY or HEAT.
However, when operation is started again within 2 hours after it
is stopped, the same operation mode before the operation is
stopped is selected. The operation mode selected first is not
changed even if the room temperature changes. If the operation
mode does not match the room condition, select the appropri-
ate operation mode by pressing the
Details of auto operation
COOL & HEAT type
Room temperature Operation mode
when started
About 25°C or higher COOL
About 25°C - 23°C DRY
°
C.
About 23°C or lower HEAT
NOTE
COOL: When the room temperature is 2
changed since the air conditioner is operating to reach the target (set) temperature. In this case,
please wait until the room temperature drops to within 2
°
C.
the set temperature.
HEAT: When the room temperature is 2
changed since the air conditioner is operating to reach the target (set) temperature. In this case,
please wait until the room temperature rises to within 2
set temperature.
Details of display on the indoor unit
(DRY)
The operation indicator at the right side of the indoor unit indi-
cates the operation state.
Lighting
Blinking *
Operation
Indicator Not lighting
Operation indicator lamp
Indication
This shows that the air conditioner is operating to reach the
target temperature. Please wait until the target temperature
is obtained.
This shows that the room temperature is approaching the
target temperature.
(In case of outdoor unit MXZ series only)
Please refer to INFORMATION FOR MULTI SYSTEM AIR
CONDITIONER (page 10). *
* Except MSC-C07/C09/C12TV
MODE
button.
COOL ONLY type
Target temperature Operation mode Target temperature
(initial state) (initial state)
About 24°C COOL About 24°C
— DRY
About 26°C DRY
°
C higher than the set temperature, the set temperature may not be
°
C of the set temperature and then change
°
C lower than the set temperature, the set temperature may not be
°
C of the set temperature and then change the
Difference between target
Operation state
temperature and room temperature
—
—
About 2°C or more
About 2°C or less
—
9