Air Flow Velocity And Direction Adjustment.9 - Mitsubishi Electric MSH-07RV Operating Instructions Manual

AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT
AIR FLOW velocity and direction can be selected
as required.
X
MITSUBISHI ELECTRIC
0
CLOCK
'T'
PM
in nn
IU uu
on/off:
too m too
COOL
FAN
©STOP
Wm
( 1
1 a<°!
VANE
© START
[©-1
MODE
j-1
ECC\0 COOL
■ min-;
run
To change the AIR FLOW velocity, press
the r^i button.
Each time the button is pressed, the fan speed is
changed in sequence:« (Lo) (Med)
*a0
(Hi)
-» © (AUTO)
® Use the (Hi) notch to cool/heat the room more.
* If the operating sound of the air conditioner disturbs your
sleep, use the - (Lo) notch.
To change the AIR FLOW blowing direc¬
tion vertically, press the button.
Each time the button is pressed, the angle of the hori¬
zontal vane is changed in sequence: " (1) «' (2)
<• (3)
-> ,
(4) -» , (5) -» ^ (SWING) -» lg) (AUTO)
SWING OPERATION
Use the swing operation for the air flow to reach all corners
of the room.
Recommended horizontal vane
range
Use the <<© (AUTO) position usu¬
ally.
Use position - (1) or - (2) in the
COOL or DRY mode and use posi¬
tions
*
(3) to j (5) in the HEAT mode
when adjusting to your require¬
ments.
HEAT
■
vx
[— NOTE
In the cooling operation, when the air conditioner is op¬
erated with setting the horizontal vane to / (4) or, (5) for
1 hour, the AIR FLOW direction is automatically set to
horizontal to prevent condensed water from dropping.
Adjust the vertical AIR FLOW direction using the remote
controller. If the horizontal vane is moved manually, it
may cause trouble.
In the heating operation, if the air flow temperature is
too low or when defrosting is being done, the horizontal
vane position is set to " (1).
Auto air flow direction control operation
When the AUTO mode is selected with the □□ button, the position of the horizontal vane is automatically set
to correspond to the operation mode for effective operation.
(1) HEAT
When the air flow temperature is too low,
the air is blown out horizontally.
When the air flow temperature rises,
the air is blown out downwards.
(2) COOL, DRY
The air is blown out horizontally.
To change the horizontal direction of the air flow, move the vertical vane manu¬
ally.
Adjust the vane before operation starts.
Since the horizontal vane moves automatically, your fingers may be caught.
9