Advertisement
4. When the red has dried and cured, it is time to
paint the large white areas. To make this easier
for you, there are two masking tools inside Bag B.
5. Place the masking tools into the sides opposite
each other. Use the picture as a guide to tape
the masks into place. Use a light adhesion tape
designed for masking paint.
6. The tape on the top deck should be placed
where the taper of the deck plating meets the
thin section of plating.
7. On the lower deck portion of the masks, place a pencil mark 3/8 inches from the end of the
mask. The tape on the bottom deck should be placed on the marks of the mask.
8. Paint the exposed area gloss white.
There is a decal placed in this area so
the gloss finish just helps here.
9. Remove the masking shortly after
spraying and is dry to the touch.
Don't let set overnight though.
10. Mask the other side and paint.
Remove the masking as before.
11. Let the paint cure.
Center Body Final Assembly
1. For 340323/5 only: Apply CA to the inside of the Sheer Plate cavities on the body, then insert
the bottom side of the Sheer Plates into the cavities.
2. The painted Weld Plates can be insert into the appropriate slots on the body without glue. Be
sure the tops of the Weld Plates are parallel to each other.
Page 9 of 20
railfanmodels.com
Advertisement
