Advertisement
End Platform Assembly and Painting
1. Remove the contents of Bag D.
2. Dry fit the Sides and Ends to the Platform Cores. The
top of the Side should be flush with the top of the
Core. The joints should be tight without any gaps. If
a gap does exist, use a small file to remove material
from the side of the Core only.
3. Apply CA to one side of the Core. Use a toothpick to
evenly spread the glue over the entire surface.
4. Press the Side on the Core and hold for 8 seconds.
5. Repeat for the End, then for the opposite Side.
6. Remove one of the Lower Brake Pipes from the
cardboard enclosure.
7. Dry fit the Brake Pipe into the opening on the bottom
of the Core. You will need small needle nose or
tweezers to do this.
8. Remove the Brake Pipe, apply CA to the Core, then
press the Brake Pipe into the core with the same tool.
Page 10 of 20
railfanmodels.com
Advertisement
