Advertisement
Apply Reflectors and Decals
Use the pictures on the following pages as reference for placement. Note the few subtle differences
with each car number. Both sides of the car are the same, but make sure the A End is used on both
sides of the same End Platform. Same with the B End.
The decals are made by Microscale for Railfan Models, and go on just like any of their other decals.
Cut the decal out with enough extra paper on one side so that it can be held with small needle nose
pliers and not interfere with the decal sliding off. Dip the decal in warm water for 10 seconds and
remove. Let set for 20-30 seconds, then slid the decal off the paper into position with a toothpick.
Blot any excess water with a small piece of paper towel or small dry paint brush. Allow the decals to
dry then brush a "setting" solution over the decals and let dry. A magnifier will come in very handy
viewing, cutting, and placing the decals.
1. It is easier to place the yellow Reflectors from Bag G before placing the decals. We
recommend placing the Platform between 2 small blocks of wood to hold the Platform
vertical. Use two layers of paper towels under the blocks and Platform.
2. Place the reflectors on one side. Use a hobby knife to lift a reflector from the backing and
apply to the car body. Place into position and burnish the reflectors with a toothpick. For
more detailed instructions, go to smokeboxgraphics.com.
3. Remove the Platform, flip it to the other side, replace between the blocks, and place the
reflectors for that side.
4. Repeat for the other platform.
5. Lay the Center Body on its edge. It should lay like this without any support.
6. Apply the reflectors to this side, then flip over and repeat for the other side. Now you are
ready for the decals.
7. Apply the decals from Bag G to the Center Body sides, then top.
8. Apply the decals to the sides and ends of the Platforms.
9. Apply the car number decals to the right side of each Truck side.
10. Apply a clear gloss coat to the sides, ends, and tops of the End Platforms and Center Body to
seal the decals and reflectors.
11. Apply any weathering and/or dull coat at this time.
Page 12 of 20
railfanmodels.com
Advertisement
