Advertisement
17. Carefully twist the Cut Lever 180 degrees along the long axis
of the car. The portion of the Cut Lever through the hole will
twist to your right.
18. Move the long part of the Cut Lever to your left.
19. Line up the end of the Cut Lever with the hole on the Coupler
Cover, and move the Coupler Cover to the right so that it is in
line with the Span Bolster.
20. Tighten the Screw just enough that the Coupler Cover will not
move. DO NOT OVER TIGHEN THE SCREW!
21. Repeat Steps 12 through 20 for the other end of the car.
22. Place a little CA on the step and back of the brake manifold.
23. Place the Brake Valve as shown. This
part is pre-painted for your
convenience. Repeat for the other
end of the car.
Page 19 of 20
railfanmodels.com
Advertisement
