Advertisement
Welcome
The system that you are about to install comes factory pre-loaded with EMC
Network Server software (DART) and CLARiiON
Software upgrade
If you bought a software maintenance contract, you are entitled to a software upgrade
that is performed only after the installation, Celerra Startup Assistant (CSA), and
registration have successfully completed.
Site preparation
Complete the site preparation by verifying the following activities before instal lation:
•
Network connections
•
Power requirements
•
Rack space requirements
Default IP addresses
The system components communicate with each other using a private Internet Protocol
(IP) network. By default, this network uses the IP addresses listed in the " Internal
system addresses ."
If your existing IP network uses addresses on these subnets, you are required to
change the private network addresses of your Celerra Network Server to different
subnets before the installation.
Internal system addresses
Primary internal network
Backup internal network
Netmask
IP address of storage processor A
IP address of storage processor B
Gateway IP address of storage processor A
Gateway IP address of storage processor B
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
Before you begin
!
3
®
storage array software (FLARE
Factory values
128.221.252.100
128.221.253.100
255.255.255.0
128.221.252.200
128.221.253.201
128.221.252.104
128.221.253.104
®
Celerra
®
®
).
Advertisement
