Menu Settings - DeLonghi La Specialista EC9335M Instructions Manual

should ideally use milk at refrigerator temperature (about
5°C).
2. Choose the position of the ring (A7) (fig. 22) according to
the beverage to be prepared (see following table):
Recommended
position
3. Place the jug (C9) containing the milk under the frothing
wand (A8) (fig. 23).
4. Immerse the frothing wand in the milk jug. Never immerse
the black ring (fig. 24).
5. Turn the dial to the
milk is delivered from the frothing wand. If the ring is in the
FOAM position, the steam gives the milk a creamy frothy
appearance (fig. 26). To obtain a creamier froth, immerse
the frothing wand in the milk and rotate the container with
slow up and down movements.
6. When the required temperature (the ideal is 60°C/140°F)
and froth density is reached, interrupt steam delivery by
turning the dial to the ◯ position.
7. For beverages requiring it, prepare the coffee (see section
"4. Prepare the perfect coffee dose"). Choose sufficiently
large cups and place them on the espresso cup grille (A10).
To use tall glasses, close the espresso cup grille (A10) and
rest the glass on the cup grille for glasses or mugs (A11).
8. Pour the frothed milk into the cups. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
Please note: Preparing cappuccino: consider about 100 g (3.3 fl oz) of milk for each
cup.
10. CLEANING THE FROTHING WAND AFTER USE
For hygiene reasons, the frothing wand should always be
cleaned after use.
Proceed as follows:
1. Turn the steam dial to the
steam for a few seconds (points 2, 5 and 6 of the previous
section). This causes the frothing wand to discharge any
milk left inside.
2. Press the (B1) ON/Standby button to turn the appliance off.
3. Wait a few minutes for the frothing wand to cool down.
With one hand, hold the frothing wand tube firmly, with
the other, release the frothing wand by turning it anticlock-
wise, then pull off downwards (fig. 27).
4. Remove the rubber steam connection nozzle from the
spout by pulling it downwards (fig. 28).
Milk beverage to be
prepared
Hot milk (not frothed) /
Caffelatte / Macchiato / Flat
White
Cappuccino, Espresso Mac-
chiato, Hot Milk (frothed)
position (fig. 25). Steam to heat the
position to deliver a little
5. Push the ring upwards and make sure the two holes shown
by the arrows in fig. 29 are not blocked. If necessary, clean
with a pin;
6. Replace the connection nozzle, move the ring downwards
and put the frothing wand back on the nozzle, turning it
and pushing it upwards until it is attached.
For more thorough cleaning, use De'Longhi detergent.
11. ACTIVATING THE WATER SOFTENER FILTER
Certain models are fitted with a water softener filter (C6). If this
is not the case with your model, you are recommended to pur-
chase one from De'Longhi Customer Services.
To use the filter correctly, follow the instructions below.
1. Remove the filter from the packaging;
2. Turn the date indicator disk (fig. 30) until the next 2 months
of use are displayed;
Please note: The filter lasts about two months if the appliance is used normally. If the
coffee machine is left unused with the filter installed, it will last a maximum of 3 weeks.
3. To activate the filter, run tap water through the hole in the
filter (fig. 31) until water comes out of the openings at the
side for more than a minute;
4. Extract the tank (A17) (if necessary fill with water);
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 32);
6. Place the filter in the filter housing (A18) and press as far
as it will go. Close the tank, then put the tank back in the
machine;
The filter is now active and you can use the coffee machine.

12. MENU SETTINGS

Please note: Once in the menu, you can modify all the menu functions as described
in the following sections.
12.1 Coffee temperature
To change the temperature of the water used to make the coffee,
proceed as follows:
1. Press and hold the
er for at least 3 seconds to access the menu. The
and (B16) lights alternate;
2. Turn the mode selection dial (B8) to the
position. The light (B11) remains on steadily;
3. Press the button corresponding to the desired selection as
shown in the following table:
Button
4. Press the button (B1) to exit the menu. (If the appliance
is left idle for about 1 minute, it exits automatically from
the settings menu and returns to regular use mode).
11
(B3) and (B7) buttons togeth-
ESPRESSO
Temperature
Standard
High
(B15)