DeLonghi La Specialista EC9335M Instructions Manual page 16

PROBLEM
If you want to change the type of coffee You must remove all the beans present
After grinding, the coffee filter is empty The coffee mill coffee guide is clogged
After grinding, there is too much coffee
in the filter
After grinding, the ground coffee in
the filter does not reach the "perfect
amount of coffee"
CAUSE
in the machine
The "Smart Tamping Station" needs
cleaning
The quantity of ground coffee needs
adjusting
Over time the burrs wear down
21
SOLUTION
• Empty the bean container (if necessary,
operate the coffee mill without beans
or use a vacuum cleaner to remove any
remaining beans).
• Attach the portafilter and operate the
coffee mill a number of times without
beans to free the coffee guide. Attach
the portafilter to the outlet of the mill
(A22), lining it up with "INSERT", then
turning it to the right (fig. 22). Grinding
begins when the portafilter reaches the
CLOSE position and stops automatically.
Repeat until the filter is empty.
• Place the new coffee in the bean container.
• If the amount of coffee ground is not
enough to reach the "perfect quantity", pro-
ceed as described in section "4.4 Adjusting
the quantity of ground coffee in the filter".
Clean as described in section "13.10 Cleaning
the "Smart tamping station". If the problem
persists, access the guide by opening the hatch
and free it using the brush (fig. 50).
Clean as described in section "13.11 Cleaning
the "tamping station", then grind again.
Adjust the quantity of coffee with the dial
(B2), following the instructions in section
"4.4 Adjusting the quantity of ground coffee
in the filter". If the dial is already in the max.
position, contact De'Longhi Customer Service
who will guide you to reach the perfect dose
again (see "www.delonghi.com")
Contact De'Longhi Customer Service who will
guide you to reach the perfect dose again
(see "www.delonghi.com")
50