Vyaire MicroRPM Operating Manual page 25

Guidance and Manufacturer's Declaration – Electromagnetic
Immunity
The Micro RPM is intended for use in the electromagnetic environment
specified below. The customer or the user of the Micro RPM should assure
that it is used in such an environment.
Immunity Test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
IEC 60601 test
level
Contact: ± 8 kV
Air:
±2 kV, ± 4 kV, ±
8 kV, ± 15 kV
± 2 kV
100 kHz
repetition
frequency for
power supply
lines
± 1 kV
100 kHz
repetition
frequency for
signal lines
± 0,5 kV, ± 1 kV,
± 2 kV
Compliance
Level
Contact: ± 8 kV
Air:
±2 kV, ± 4 kV, ±
8 kV, ± 15 kV
Not Applicable
Not Applicable
25
Electromagnetic
Environment
-Guidance
Floors should be
wood, concrete
or ceramic tile. If
floors are covered
with synthetic
material, the
relative humidity
should be at least
30%.
Mains power
quality should be
that of a typical
commercial
or hospital
environment.
Mains power
quality should be
that of a typical
commercial
or hospital
environment.