Monte Carlo Fan Company 3VNMR56 D-V1 Series Owner's Manual And Installation Manual page 5

13
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
16
Reverse switch
Setting the reverse switch on the left
hand side will result in downward airflow
and setting the switch on the right hand
side will result in upward airflow.
Note: Reverse switch must be set either
way completely. If the reverse switch is
set in the middle position, fan will not
operate.
© 2015 Monte Carlo Fan Company
14
Plate on motor
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
Install blanking plate
17
LED Module
Light shade
Light plate
Remove LED module and Light shade
from Light plate as shown in illustration.
Keep screws.
15
Light pan
LED light kit
Connect white wire from fan to white wire
from LED light kit and then connect blue
wire from fan to black wire from LED
light kit.
Attach LED light kit to light pan by
locating dimples in light pan with grooves
on the LED light kit and twist clockwise
until tight.
Note
fan with LED light, go to step 17 for
blanking plate installation.
18
Install blanking plate onto light plate using
the set screws of light shade which were
just removed.
5
Install LED Light Kit
: If you don't want to install the
Blanking
plate
Light plate
Blanking plate assembly
12/2017