Texas Instruments TPL5010EVM User Manual

Texas Instruments TPL5010EVM User Manual

Evaluation module

Advertisement

Quick Links

This user's guide provides the setup instructions, configuration, and operation of the TPL5010 evaluation
module (EVM). Also included are the printed-circuit board (PCB) layouts, schematic, and the bill of
materials (BOM).
...................................................................................................................
1
..........................................................................................................................
2
2.1
2.2
2.3
....................................................................................................................
3
3.1
4
...................................................................................................................
5
6
1
2
3
J1 Jumper Setting
4
5
6
7
8
9
10
11
12
....................................................................................................................
13
14
15
1
2
3
4
5
6
LaunchPad is a trademark of Texas Instruments.
DURACELL is a registered trademark of The Gillette Company.
SNAU173 - January 2015
Submit Documentation Feedback
..........................................................................................
..............................................................................................
.......................................................................................
...................................................................................
................................................................................................................
.............................................................................................................
................................................................................................................
...........................................................................................................
...........................................................................................................
...........................................................................................................
.......................................................................................................
......................................................................................................
................................................................................................................
..................................................................................................
......................................................................................
......................................................................................
.........................................................................................................
.......................................................................................
.....................................................................................................
...........................................................................................
Copyright © 2015, Texas Instruments Incorporated
TPL5010 Evaluation Module
Contents
List of Figures
..................................................
....................................................................
........................................................................
.........................................................................
.......................................................
List of Tables
User's Guide
SNAU173 - January 2015
..................................
TPL5010 Evaluation Module
2
3
3
5
5
11
11
14
16
17
2
3
3
4
4
4
6
7
8
11
12
13
14
15
16
2
3
3
4
4
17
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TPL5010EVM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Texas Instruments TPL5010EVM

  • Page 1: Table Of Contents

    Switches and Selectors Description ..................... Test Points Description ................... TPL5010EVM Bill of Materials LaunchPad is a trademark of Texas Instruments. DURACELL is a registered trademark of The Gillette Company. SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 2: Introduction

    MANUAL_DRV Figure 1. TPL5010EVM TI's TPL5010EVM evaluation module (EVM) allows a designer to configure the timer intervals of the TPL5010 and measure its very low current consumption. Moreover, the TPL5010EVM is ready to be connected to the LaunchPad™ of the MSP430F5529 in order to test its watchdog and timer features. The EVM has an onboard battery holder (coin battery) to supply the TPL5010 and the microcontroller, if connected.
  • Page 3: Setup

    Name Layer Description J1/J3 Bottom 2 × 10 pin receptacle to plug the TPL5010EVM into the MSP430F5529 LaunchPad J4/J2 Bottom 2 × 10 pin receptacle to plug the TPL5010EVM into the MSP430F5529 LaunchPad Bottom 2-pin receptacle to plug the TPL5010EVM into the MSP430F5529 LaunchPad...
  • Page 4: J2 Jumper Setting

    Test point of the ground, connect the GND of the power supplies V_BATT Test point to monitor battery voltage AUX_VDD Test point to connect external supply voltage in alternative to the coin cell battery TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 5: Battery Requirements

    Alternatively, set the DRV pulse interval with the fix resistances (R_EXT1 = 500 Ω, R_EXT2 = 0 Ω). If required, replace the resistances with customized ones. Figure 1 for locations of the resistances REXT1 and REXT2. SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 6: Jumpers Configuration - Evm Standalone Without Microcontroller

    The DONE and WAKE signals can be monitored at the IO connector (pin 2 and 3, respectively). S_ON_OFF CR2032 I_SEL R_SEL WAKE DONE Figure 7. Jumpers Configuration – EVM Standalone Without Microcontroller TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 7: Jumpers Configuration - Evm With Microcontroller

    S_ON_OFF CR2032 I_SEL R_SEL µC GPIO GPIO RSTn WAKE DONE Figure 8. Jumpers Configuration – EVM With Microcontroller SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 8: Jumpers Configuration - Evm With Launchpad

    Put the S_ON_OFF selector in ON position, or turn on the external voltage source if it is used instead of the coin cell battery. S_ON_OFF CR2032 I_SEL J1/J3 J4/J2 R_SEL Figure 9. Jumpers Configuration – EVM With LaunchPad TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 9 // Done Low P2IES &= ~BIT0; // P2.0 Lo/Hi edge P2IFG &= ~BIT0; // P2.0 IFG Cleared P2IE |= BIT0; // P2.0 Interrupt Enabled SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 10 // Done High __delay_cycles(100); // Set Delay; P2OUT &= ~BIT3; // Done Low; break; case SYSUNIV_OFIFG : case SYSUNIV_ACCVIFG : case SYSUNIV_BUSIFG : default : break; TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 11: Operation

    Turn on the EVM (ON/OFF switch to ON position). • Read the current consumption on the DMM. S_ON_OFF CR2032 I_SEL R_SEL Figure 10. Current Measurement Setup – TPL5010 Only SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 12: Current Measurement Setup - Tpl5010 During The Reading Of The Resistance

    Read the current consumption on the DMM. S_ON_OFF CR2032 I_SEL R_SEL MANUAL RESET Figure 11. Current Measurement Setup – TPL5010 During the Reading of the Resistance TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 13: Current Measurement Setup - Tpl5010 With Microcontroller

    Read the current consumption on the DMM while pressing the MANUAL_RESET switch. S_ON_OFF CR2032 I_SEL R_SEL µC GPIO GPIO Figure 12. Current Measurement Setup – TPL5010 With Microcontroller SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 14: Board Layout

    Board Layout www.ti.com Board Layout Figure 13 Figure 14 illustrate the TPL5010EVM board layouts. Figure 13. Top Layer TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 15: Bottom Layer

    Board Layout www.ti.com Figure 14. Bottom Layer SNAU173 – January 2015 TPL5010 Evaluation Module Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 16: Schematic

    Schematic www.ti.com Schematic Figure 15 illustrates the TPL5010EVM schematic. Figure 15. TPL5010EVM Schematic TPL5010 Evaluation Module SNAU173 – January 2015 Submit Documentation Feedback Copyright © 2015, Texas Instruments Incorporated...
  • Page 17: Bill Of Materials

    Bill of Materials www.ti.com Bill of Materials Table 6 lists the TPL5010EVM BOM. Table 6. TPL5010EVM Bill of Materials Designator Description Manufacturer Part Number Quantity AUX_VDD Test Point, TH, Miniature, Red Keystone 5000 Battery Holder, CR2032, Retainer clip, TH Memory Protection Devices...
  • Page 18 STANDARD TERMS AND CONDITIONS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, or documentation (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms and conditions set forth herein. Acceptance of the EVM is expressly subject to the following terms and conditions.
  • Page 19 FCC Interference Statement for Class B EVM devices NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 20 【無線電波を送信する製品の開発キットをお使いになる際の注意事項】 開発キットの中には技術基準適合証明を受けて いないものがあります。 技術適合証明を受けていないもののご使用に際しては、電波法遵守のため、以下のいずれかの 措置を取っていただく必要がありますのでご注意ください。 1. 電波法施行規則第6条第1項第1号に基づく平成18年3月28日総務省告示第173号で定められた電波暗室等の試験設備でご使用 いただく。 2. 実験局の免許を取得後ご使用いただく。 3. 技術基準適合証明を取得後ご使用いただく。 なお、本製品は、上記の「ご使用にあたっての注意」を譲渡先、移転先に通知しない限り、譲渡、移転できないものとします。 上記を遵守頂けない場合は、電波法の罰則が適用される可能性があることをご留意ください。 日本テキサス・イ ンスツルメンツ株式会社 東京都新宿区西新宿6丁目24番1号 西新宿三井ビル 3.3.3 Notice for EVMs for Power Line Communication: Please see http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page 電力線搬送波通信についての開発キットをお使いになる際の注意事項については、次のところをご覧くださ い。http://www.tij.co.jp/lsds/ti_ja/general/eStore/notice_02.page SPACER EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS.
  • Page 21 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2015, Texas Instruments Incorporated...
  • Page 22 IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue.

This manual is also suitable for:

Tpl5010

Table of Contents