Table of Contents
Advertisement
The LDWS does not operate
when:
• The driver turns on the turn signal
to change lane.
But, when the hazard warning
flasher is operating, the LDWS
operates normally.
• Driving on the lane line.
✽ ✽ NOTICE
To change lane, operate the turn sig-
nal switch, then change the lane.
The LDWS may not warn you
even if the vehicle leaves the
lane, or may warn you even if
the vehicle does not leave the
lane when:
• The lane is not visible due to snow,
rain, stain, a puddle or many other
things.
• The brightness of the outside
changes suddenly.
• Not turning on the headlight even
at night or in the tunnel.
• Difficult to distinguish the color of
the lane from the road.
• Driving on a steep grade or a
curve.
• Light reflects from the water on the
road.
• The lens or windshield is stained
with foreign matter.
• The sensor can not detect the lane
because of fog, heavy rain or
heavy snow.
• The surrounding temperature of
the inside rear view mirror is high
due to a direct ray of light.
• The lane is very wide or narrow.
Driving your vehicle
• The lane line is damaged or indis-
tinct.
• The shadow is on the lane line by a
median strip.
• There is a mark similar to a lane
line.
• There is a boundary structure.
• The distance from vehicle ahead is
very short or the vehicle ahead
hides the lane line.
• The vehicle shakes heavily.
• The lane number increases or
decreases or the lane lines are
crossing complicatedly.
• Putting something on the dash-
board.
• Driving with the sun in front of you.
• Driving in areas under construc-
tion.
• The lane line is more than two in
either side (Left/Right).
5 65
Advertisement
Table of Contents
