Introduction; Safety Information - SATA 03022 User Manual

Introduction

This meter is a 3 3/4-digit digital clamp meter with automatic range. It may be used
for measuring AC/DC voltage, AC/DC, resistance, capacitance, frequency, diode and
circuit continuity. It is an ideal measuring tool, with such functions as relative value
measurement, data hold, low battery voltage indication, overrange indication and
automatic power-off.

Safety information

The meter is designed to conform to Pollution Degree 2 and Overvoltage Category
CAT Ⅲ 600V as specified in IEC-61010.
Safety instructions
To avoid electric shock and personal injury, please follow the following operating
requirements:
1. The meter shall be used with the method specified in this manual; otherwise, protective
measures provided by the meter may be damaged.
2. Do not use the meter if it is damaged. Check the casing before use, especially the
insulation around the connectors.
3. Check the insulation of the probes for damage or exposed metal. Check if the probes
are conductive. If a test probe is damaged, please replace it with a new one for
continued operation.
4. If the meter is not working properly, do not use it. Its protective device may have been
damaged. If you have any doubt, the meter should be sent for repair.
5. Never use the meter near explosive gases, vapors or dust.
6. Never apply a voltage greater than the rated voltage indicated on the meter between
the terminals or between the ground and any terminal.
03022
- 15 -
EN DE RU KO PT JA ES