Touch Screen Calibration; Wiring Diagram; Troubleshooting - Planet Audio P9756 User Manual

Touch screen Calibration

Please follow the below instructions to calibrate when there is no touch or
touch is not accurate.
Step 1: Press the mode button in the unit to switch to DVD mode.
Step 2: Insert a DVD disc, after DVD is loaded, press the stop button "
picture (1). in the remote short, the unit will display as show in picture (2).
Picture ( 1 )
Step 3: Press " " in the remote as show in picture (3), the unit will display as show in
picture (4).
Picture ( 3 )
Step 4: Press " " button in the remote and then quickly press "
picture (5) and you will enter the touch calibration interface as show in picture (6).
Picture ( 5 )
Step 5: Use the touch pen to touch top left corner, top right corner, down right corner,
down left corner, when the cross cursor stop at each corner, touch the center of the
cursor. Then the panel will display OK and leave the calibration interface and the unit
regained touch as show in picture (7).
" as show in
Picture ( 2 )
Picture ( 4 )
" button as show in
Picture ( 6 )
Picture ( 7 )
This player is equipped with ISO standard connector, please follow below instruction:
Red - ACC ON (+12V)
●
Yellow – 12 V Constant
●
Black – Ground wire
●
Blue - Power Antenna / Remote Amp Turn On
●
Violet/White-Reverse Gear Signal (+)
●
TROUBLE SHOOTING
PROBLEM CAUSE
Check fuse
Cannot power on
Some factors cause MPU
wrong operation
After ignition switch
Change battery or fuse
off, setting
information all lose
Poor performance
Weak signal
of radio station
There is a disk inside
Cannot load disk
Disc is scratched
Put wrong side of disc into
Cannot play disc
the unit
Lens is dirty
Cannot switch
There is only one language/
language/subtitle
subtitle in disc
Other factors cause MPU
No image
wrong operation
Cannot watch
It's not allowed to watch image
image during
during driving
driving

WIRING DIAGRAM

Grey/Grey black - Right front speaker (+/-)
●
White/White black - Left front speaker (+/-)
●
Purple/Purple black - Right rear speaker (+/-)
●
Green/Green black - Left rear speaker (+/-)
●
Light Green-Parking Brake (-)
●
SOLUTION
Change fuse same as the old one
Press RES button on the panel by penpoint,
then, power on
Reset information and save
Move the car to another place, then research
Remove disc before inserting another one
Change new disc
Insert in the disk with sign side up
Clean lens by lens clean disc
If disc is not with multi-language/subtitle, it
cannot switch language/subtitle
Press RES button on the panel by penpoint,
then, power on
Park the car in a safe place, put the car stall
in " P " postion, pull up the hand brake,
parking brake wire must be grounded