Unpacking And Removing Shipping Bolts - LG WM0001HTMA User's Manual & Installation Instructions

UNPACkING AND REMOVING SHIPPING BOLTS

When removing the washer from the carton base, be
sure to remove the foam tub support in the middle of the
carton base.
If you must lay the washer down to remove the base
packaging materials, always lay it carefully on its side. Do
NOT lay the washer on its front or back.
IMPORTANT: To prevent internal damage during transport,
the washer is equipped with 4 shipping bolts and plastic
retainers. These bolts and retainers MUST be removed
before operating the washer.
• Failure to remove shipping bolts and retainers may cause
severe vibration and noise, which can lead to permanent
damage to the washer. The cord is secured to the back of
the washer with a shipping bolt to help prevent operation
with shipping bolts in place.
1 Starting with the bottom 2 shipping bolts,
use the included wrench to remove the
4 shipping bolts by turning them
counterclockwise.
w WARNING
To reduce the risk of injury to persons when using this cleaner,
follow basic To reduce the risk of fire when using and install this
appliance
follow basic precautions, including the following :
• Do not install nearby heat item. Such as stove, cooking oven.
Failure to do so can cause deform, smoke and fire.
• Do not place candle and cigarettes on top of the product.
Failure to do so can cause deform, smoke and fire.
• Remove all protective vinyl film from the product.
Failure to do so can cause deform, smoke and fire.
Removing the Protective Film
The top, sides, and front of the washer are covered
with a protective vinyl film. This film is to protect
the finish during shipping, and should be removed
before use.
I N S TA L L AT I O N I N S T R U C T I O N S
Shipping
Bolts
2
Once the protective film has been removed, transfer
the Service Call Number label from the top film to an
easy to find location on the side of the washer.
Foam Tub
Support
Hole Cap
Remove the retainers by turning them slightly
while pulling. Rotate and press the hole caps
into the shipping bolt holes.
NOTE: Save the bolts and retainers for
future use. To prevent damage to internal
components, the shipping bolts and
retainers must be installed when
transporting the washer.
Carton Base
Retainer
11