Table of Contents
Advertisement
Help Guide
Flash
HVL-F60RM/HVL-F60RM2/HVL-F46RM
Removing/attaching the dust and moisture resistant cover (HVL-F60RM2/HVL-F46RM)
Depending on the external design of a camera, the dust and moisture resistant cover attached to this flash unit may come in contact with the
camera body, but you can still attach the flash unit to the camera and use it for photography.
To secure the effect of dust and moisture resistance, make sure you attach the cover properly to the flash unit by following these steps.
Note
The illustrations used in this topic are of the HVL-F60RM2 flash unit.
To remove the dust and moisture resistant cover
Push down a corner of the dust and moisture resistant cover to take it off of the Multi Interface foot.
To attach the dust and moisture resistant cover
Press and hold the release button and rotate the lock lever away from "LOCK."
1
Orient the dust and moisture resistant cover with respect to the Multi Interface foot of the flash unit.
2
Attach the dust and moisture resistant cover by tucking its four inner corners into the gap above the Multi Interface foot.
3
27
Advertisement
Table of Contents
