Advertisement
8 Route the wire to the top case.
Important
Hold the cables in place with clamps to prevent undue force from
being applied to the terminal block and causing cable breakage.
9 Install the front cover and top case on the bottom case.
Two mounting tabs are at the top of the top case. (A cover is already installed on the case at the time of factory shipment.)
Hook those two tabs onto the bottom case, and click the top case into place. Check that the case is securely installed and not lifted.
Important
When attaching the cover and the top casing to the bottom casing,
push it until it they click into place.
If they are not properly locked into place, they may fall, causing
personal injury, controller damage, or malfunctions.
Direct wall installation (when running the cable along the wall)
● Thread the cable through the access hole at the top of the
remote controller.
● Seal the cut-out part of the cover with putty.
● Use a cable cover.
Installation is complete.
Follow the instructions below when uninstalling them.
(2) Uninstalling the front cover and top case
1 Uninstalling the front cover
Insert a flat-tip screwdriver into either of the two latches at the
bottom of the remote controller, and move it in the direction of
the arrow as shown in the figure at right.
2 Uninstalling the top case
Insert a flat-tip screwdriver into either of the two latches at the
bottom of the remote controller, and move it in the direction of
the arrow as shown in the figure at right.
Important
Use a flat-head screwdriver with a blade width of 4-7 mm (5/32-9/
32 inch). The use of a screwdriver with a narrower or wider blade
tip may damage the controller casing.
To prevent damage to the controller casing, do not force the driver
to turn with its tip inserted in the slot.
To prevent damage to the control board, do not insert the driver
into the slot strongly.
Insert the wire.
Seal the gap with putty.
Eng-7
Clamp
Wall
No lifting
Use a cable cover.
Thread the cable through the
top of the remote controller.
Advertisement
